I'm not sure about your particular vehicle here. But if you don't see any nuts at the base of the wiper arm, you'll probably want to use a special tool. Usually these tools can be found at any auto parts store if you tell them what kind of vehicle you drive. They're generally not that pricey. It shouldn't be any different than any other. At the base of the wiper arm is a cap that lifts up. Under the cap is a nut. Propbably takes a half inch wrench. Unscrew the nut and pull off the wiper arm.
How do you Change Windshield Wiper Blades on a 2004 Chevrolet Trail Blazer?
you just pick up the wiper arm
if its not mounted to the firewall just above and at the rear side of the motor then it is on the opposite side of firewal bellow the wiper arms
Remove the old wiper and replace with a new one
Remove fuel tank
The wiper arms have a flip-up cover that you need to pop up in order to get at the bolt.
I have a 2004 Chevy Blazer that I believe had the same issue as you. The wiper arm has a plastic covering over it. You will need to remove it. I using a a Flat head screw driver pry it off where the wiper arm bends. This will allow the base of the plastic piece to pop off the rear of the wiper arm. You can now take a 1/2" socket and tighten up the nut that is under that plastic covering. That was the solution for me anyhow. My driver side wiper arm wasn't moving at all, but the passenger side was. Hopefully that works for you.
The rubber insert on the rear wiper of the 2004 Sienna comes off when you pull the insert away from the wiper while squeezing the tabs on the back of the wiper. The entire rubber insert is replaced when you squeeze the two tabs at the back of the wiper and slide the new insert into place.?æ
Remove winshield wiper assembly to remove altrnator,i know ive done it
It is located under the windshield cowl (the plastic cover with the holes in it, directly under the windshield). To expose it - remove the wiper arms, and the retaining nuts on the wiper shafts, then remove the screws holding down the cover.
First remove the plastic cover at the fixed end, this will allow you to lift the wiper arm up and you can then unclip
remove fuel tankremove fuel pump module assembly unitreplace unit
Driver side behind alternator. You must remove alternator to change it
No it does not if it is a s10 blazer
The 2004 Chevrolet Tahoe has hook-end wiper arms. Press a little tab where the wiper blade is inserted into the hook. Then pull the wiper blade out of the hook. Be sure to purchase the correct replacements first by looking up your vehicle in the wiper blade books at the store or lookup wiper blade size online. Below are some videos - watch the videos for U-Hook arms.
It is under the plastic cover right below windshield. YOu have to remove retaining clips.
Remove two push on caps on wiper arms. Remove nuts and wiper arms, disconnect washer hoses. Remove "push in" plastic retainers on plastic cowl grille and remove grille. Disconnect electrical plug on motor. Remove 3 bolts securing wiper transmission/motor. Lift out assembly. Remove motor from transmission - 2 torx screws and nut on motor shaft @ trans link. Note position of trans link on motor shaft. Reverse all to reinstall.
Assuming that you mean "wiper blade" (blade and frame) which are replaced often rather than "wiper arm" (piece from the spindle at the hood to the wiper blade) which are rarely ever replaced, 2004 Buicks will have various attachments. You'll have to determine which attachment you have by looking at them. Then see the Sources and Related Links section below for installation videos.
Pull the wiper arm away from the rear glass. Pivot the blade so that it is perpendicular to the arm and push towards the wiper arm, and voila! See sources and related links below for wiper blade installation videos and for information on the special rear wiper blade.
The 2004 Chevy Blazer front grill emblem is held in place with two retaining nuts. You can access the retaining nuts from behind the emblem. Remove the retaining nuts and the emblem will come off.
The 2004 Toyota RAV4 rear wiper blade size is a special 12" rear wiper blade that is very simple to replace once you find a replacement. Unfortunately, most stores do not stock this special rear wiper blade. See the Sources and Related Links section below for more information on the wiper blade itself and installation videos. Once you get the wiper blade, there will also be step-by-step instructions on the packaging. Very easy install.
Where is diverter that controls air direction located in a 2004 Chevy S10 Blazer?
If you mean coolant temperature sensor.... ITs on the driver side, behind the alternator. Must remove the alternator!