May have a horseshoe type clip on the concealed back side Tool available at auto parts store -not expensive
I have to jump start my Pontiac Bonneville 1988 everyday I drive it why is that.
how am i supposed to no? I cant even drive yet xD
1-3-4-2. Cylinder 1 is at the front of the Engine (where Belt(s) are) if rear drive and at the Right (Passenger) side for Front Wheel Drive.
You can test drive a Pontiac G6 convertible at a local Pontiac dealership. You may also be able to locate a used car dealership that has a Pontiac G6 convertible and be able to test drive the car there.
do you have the Diagram for drive belt on 1993 Chevy astro van
The drive belt diagram for your ML 270, can be obtained from most Mercedes-Benz dealerships. The drive belt diagram can be found at many auto-parts stores.
no their not front wheel drive you must be thinking of a Pontiac grand am or a grand prix
drive cycle for 1998 pontiac grand prix, 3.8 engine, no super charge?
The Pontiac grand prix became front wheel drive in 1988-present. Before '88 it was rear wheel drive.
This link has many helpful diagrams. There should also be one under your hood by the belt labeled Accessory Drive Belt Routing. So if you find the diagram on your car you can match it to the diagram in this link and it will even tell you what to loosen to get the belt off. http://www.2carpros.com/car_repair_information/tec_info/2001/pontiac/aztek/2001_pontiac_aztek_drive_belt_routing_diagram.htm
we need to know how to remove and installation on ball-joints for a ford f250 3/4 ton 2 wheel drive
Test Drive - 2002 Pontiac G8 was released on: USA: 19 April 2008
Need a diagram for 1997 dodge van drive belt installation
The drive belt layout diagram can be obtained from most auto-parts stores. When you purchase a drive belt, the diagram should come with it.
No. They will stay on the hard drive.
I need a diagram of ford F350 drum brakes on 1996 model 460 engine 4 wheel drive
At the end of the starter motor shaft. Remove the starter and look in the opening that faced the transmission and you will see the gear.
fuel pump is in gas tank you might have to drop your exhaust and or center support for drive shaft. to remove gas tank.
A diagram can be found in the related links.
You probably have a loose wire and when you put it in gear the engine tilts and comes in contact with your loose wire
no , rear wheel drive only