0
How do you remove the front intermediate shaft on a 2001 dodge ram?
Wiki User
∙ 15y ago
knock it out (very carefully) from the inside of the front diff, or weld a slide hammer to the out board side and slam slam slam . ROBERTO IN KODIAK
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
87 Dodge Dakota 4x4 starter removal?
You have to remove the steering intermediate shaft and remove the starter from the top.
Will a 94 Dodge Dakota intermediate shaft fit in a 97 Dodge Dakota?
No
Will a 94 intermediate shaft fit in a 97 dodge dakota?
No
How do you remove a front axle shaft in a 1988 dodge ramcharger 4x4?
like you do in any other vehicle
How do you remove the hub and rotor assembly to take out the jack shaft on a 2003 dodge ram 2500 4x4?
a jack shaft is the small drive shaft from transfer case to front differential, brakes have nuthing to do with removal of a jack shaft maybe you mean removal of front axle
How do you install oil pump intermediate shaft on Chevrolet 396 engine?
You would need to drop the oil pan and remove the oil pump to gain access to the intermediate shaft.
Dodge Durango rear drive shaft removal?
How do you remove drive shaft from a 03 durango
Drive shaft and intermediate shaft the same?
is the drive shaft the same as the intermediate shaft on a vauxhall corsa car does any body no
Replacing front drive shaft On a 1994 Dodge Ram 1500 4x4?
front drive shaft, how do you get the yoke out of the transfore case to replace the ceal?
How do you replace the steering column shaft coupler on a 1998 Dakota?
1. Position the front wheels straight ahead. Place a steering wheel holder, SNAP-ON TOOL, p/n WA96A, or equivalent, between the steering wheel and the driver's seat to secure the wheel. 2. Remove the toe plate nuts (Figure 1). 3. Remove the pinch bolt and nut securing the upper intermediate shaft to steering column. 4. Open the hood of the vehicle and remove the pinch bolt securing the lower intermediate shaft to the steering gear. 5. Compress the intermediate shaft and remove it from the vehicle. 6. Feed the new intermediate shaft, p/n 55351171AA, through the cowl panel and install it onto the shaft splines of the steering gear. Then, compress and/or lengthen the intermediate shaft enough to be able to install the shaft onto the lower end of the steering column. 7. Secure the intermediate shaft to the lower end of the steering column with a new pinch bolt, p/n 06504926AA, and nut, p/n 06101510, and tighten the nut to 49 Nm (36 ft. lbs.). 8. Secure the intermediate shaft to the steering gear with a new pinch bolt, p/n 06504926AA, and tighten the bolt to 49 Nm (36 ft. lbs.). 9. Install the toe plate onto the cowl panel studs. Tighten the toe plate nuts to 10 Nm (90 in. lbs.). 10. Remove the steering wheel holder from the steering wheel. Information removed from www.alldatapro.com
Where is the front main seal on a dodge caravan?
It is on the front of the crank shaft. It seals the oil at the crank pulley.
What does steering intermediate shaft do?
The steering intermediate shaft connects the end of a column to the rack. The shaft can have more problems in a pickup than in a car.
