Hyundai
Hyundai Accent

How do you remove the glove-box 1998 Hyundai Excel?

575859

Top Answer
User Avatar
Wiki User
Answered
2011-03-23 01:49:38
2011-03-23 01:49:38

I have come to the conclusion myself that the only way to remove the glovebox in a Hyundai Excel is .................................................................................................................get a hammer and smash it to bits

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Hi Try this http://www.carstereohelp.com/stereoremovalHyundaiExcel.htm


If the Hyundai is a 1998 model, the related question should do the trick.


Yes they are; and they are a pain to remove.



To remove a glove box from a 1998 Honda CR-V, first pull the unit out. Locate all the mounting screws and remove them. Then pull the glove box out.


pull it up on the front edges on either side


Ue exactly what Hyundai recommends which is SAE 10w-30 weight. I would recommend a High Mileage Oil any major brand.


Get a manual on your car and do the job right the first time.


behind the glove box, some models require pulling the dash, some you can just remove the glovebox.


On the shifter there should be a button that says something to the effect of "O/D off" push it.


I have a 1998 Hyundai Elantra and had the rotors replaced, you will have to have a shop to do it because they have to be pressed off and then back on again with a specialized machine or tool. Of course unless you have that tool you can do it yourself. Good luck.


Factory stereos in a 1998 Hyundai is held in place by a mounting bracket found inside the center console. Remove the center console to reach the mounting bracket. Loosen the mounting screws and pull the radio forward. Pull the radio harness from the cabin wire harness and remove the radio.


It is located under the rear seat. To access you must first remove the cover.


Refer to the Australian Gregory's Automotive book No 269 and page 229 Hyundai excel (body and ventilation). Sold at any super cheap auto.


I had to do this on my 1997. You have to order the part. The blower is located behind the glovebox, just remove the glovebox and look up behind it and you should see it. I think three screws hold it in place. Keep track of which screws go where as there were quite a few when i did it.


there are clips that hold it in so you have to get a spot that you can pop out the clips than undo the rest


Change front brake rotors on a 1998 Hyundai Accent?


Just start and drive the vehicle the way you normally drive it, most ECU equipped cars learn you habits and adjust accordingly...


Is Hyundai own engine, known as beta engine


Hyundai Samho Heavy Industries was created in 1998.


Hyundai have added a trick to starting the engine - you need to have the clutch pedal in regardless of whether or not the car is in gear. Unless the clutch is in, the engine won't fire.


scoupe turbo engine, tiburon's 2.0 engine, 1998-99 Mitsubishi eclipse... all of this engines fit but some modifications have to be done mainly in the engine mounts




The firing order on a 1998 Elantra is 1,3,4,2



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.