Simply remove the linkage, spring, and control arm. Letting the crank or air vane run free is fine, but you risk extreme engine damage from overspeeding. Example: a 5 hp horizontal shaft L-head left at wide open throttle will go from idle to 8000 rpm (guaranteed connecting rod failure) in a little less than 2 seconds, OHV engines even faster!
It is located in your vehicles computer very complicated. If removed wrong it can cause problems
There is no way to remove the governor on a 00 Alero. One can only program its software with the use of a power programmer to be able to change the speed limiter.?æ?æ
you upgrade the bel to a high end bel and remove the clutch spacer I have a 2004 Polaris and it goes 67 mph but remember to upgrade the belt or you'll fry it in about 50-100 miles at so
There is no governor to remove. Speed is controlled by the ECU.There is no governor to remove. Speed is controlled by the ECU.
It has no governor, that you can remove. you can get your computer reprogramed
Most tuners/programmers will remove the governor.
You can remove the governor on an acura integra by having the ecu chipped.
There is no governor to remove. Speed is controlled by the ECU (computer).
There is no governor to remove. Speed is controlled by the ECU.
There is no governor per se on your Accord. The top speed is controlled by the ECU and is non-adjustable. There is no governor you can remove.
To remove the governor off a Baja 90cc refer to your owners manual. Many newer models do not have a governor.
Speed is computer controlled and there is no governor that you can remove.
You can't remove it because it does not have a governor. The speed is computer controlled.
You cannot remove what it does not have. Your Buick does not have a governor. Speed is controlled by the ECU.
It does not have a governor. Speed is controlled by the ECU.