Sounds liek a job you may need some real help on so...I
The AC power relay is located behind the right side of the dash on a 1991 Chevy Corvette. It is on top of the plenum.
You do not need to completely remove the dashboard in order to change the heater core. Remove the water hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
replace heater core in a 1991 Chevy work truck 1500
diagram for a 92 Chevy van g20 Heater core
you may have to remove the intake from the block and then use an extractor tool to remove the rest. then replace the connector.
Open both front doors and remove everything from the firewall to the front seat. No joke.
I recently installed a new heater core in a 1991 G10 van. I removed the heater fan housing, the heater core hoses, then the compartment came out. After removing the campartment has to be taken apart to replace the core. Alot of work but not all that hard.
Remove the water from the cooling system. Remove the water lines from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
The oil temp sensor on a 1991 Chevy Corvette is located on the bottom of the engine, near the oil pan. It constantly monitors the temperature of the oil and relays information to the computer.
How to remove and install the serpentine belt on 1991 Chevy Blazer with AC?
# Disconnect the negative battery cable. # Drain the engine coolant. # Remove the instrument panel/dash assembly from the vehicle. # Remove the heater hose(s) and cap the hose(s). # Remove the attaching nuts and remove the heater unit assembly. # Remove the heater core attaching screw and remove the heater core..............
You remove grill to remove and replace the headlights.
Drain the water from the cooling system. Remove the water hose from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
The 1991 Chevrolet Corvette convertible passenger side door panel is held in place with two retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on each retaining clip.
do you need to take the dash off
Unbolt it from inside, lift it out.