You remove the center cap. Under that will be a retaining nut. A special tool is used to unscrew this possibly located by your spare tire in trunk. If you do not have the tool, you can try and turn it with pliers or tap a socket over it and use a ratchet.
How Do I change the serpentine belt on a 1989 Cadillac Eldorado ?
how do u reset the anti theft system on a 1989 cadillac eldorado
You google it.
Try using the lug wrench. If the car has wire wheel caps, you will need an adapter tool to pry off the center caps and unscrew the cap from the wheel
on the middle of the steering wheel
Any steering column from a 1986-91 Eldorado would work - a comparable Seville's should work equally as well.
A 1989 Cadillac 2 door coupe sold for $26738 new.
No, they are 2 totally different bodystyles
the spring side goes down
The tire tool has a wedge on the back end of it (end you put into the jack). Put it between the rim and wheel cover and pry on it a little. Be careful not to kink the wheel cover. Large flat screwdriver will work too.
I dont know about a 1988 but my 1989 has silver rims under the hubcaps.
Itt is not a hard job. Simply remove the vacuuum line then the 2 bolts that hold it on. Clean the carbon from the manifold where it bolts. Replace the vvalve and instaall the vac line. GoodluckJoe
I've got a better question, why is this question in the Chevy venture forum ?
try a salvage yard if they dont have any try yearone.com
check the chip in the ign key. Try another key if available
The car has a new radiator and the air conditioner was serviced last year
remove lower covers under steering wheel, two screws are hidden behind heating and ac trim panel. remove the bolts to the bracket holding the steering column up. lower the steering column. the switch is located on the steering shaft underneath the dashboard instrument cluster.
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
I was shopping came out to my car and anti theft code came on when I tried to start it.
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
how do i remove the computer on a 1989 ford f-150
With the engine running and all lights and acces off approx 14 volts should be put out