0
How do you remove the hydraulic line from the slave cylinder on a 1997 Chevrolet s10?
Wiki User
∙ 14y ago
pull the cotter pin out with with a pair of pliers and and remove the the little metal sleeve the cotter pin was in. you can use a small nail to achieve this. slide the hydraulic line straight out.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is the purpose of slave cylinder?
The slave cylinder function operates from hydraulic pressure received from the master cylinder when applied. In automotive hydraulics the slave cylinder can operate such functions as the brakes, clutch or any hydraulic operation.
What holds the clutch fork on a 1993 Chevrolet 1500 bellhouseing?
A 1993 does not have a clutch fork if it is a pick-up truck. It has an hydraulic slave cylinder.
How do you remove the hydraulic clutch cable from the transmission on a 93 Ford Ranger 5 speed trans?
The hydraulic clutch slave cylinder is located on the mainshaft of the trans. You must remove the trans to get to it
Where is your slave cylinder?
The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing
How do you adjust a hydraulic clutch on a 1993 Chevrolet pickup truck?
You can't, There is no adjustment. You either have a bad clutch slave cylinder, are worn out clutch parts.
What is the purpose of the cylinder?
The slave cylinder function operates from hydraulic pressure received from the master cylinder when applied. In automotive hydraulics the slave cylinder can operate such functions as the brakes, clutch or any hydraulic operation.
Where do you find the clutch slave cylinder on a 1998 Chevrolet Cavalier?
the clutch slave cylinder on this car is located inside the transmission itself. The part has a rubber bushing that separates the the hydraulic lines and bleeder, from the section that is located in the transmission housing itself.
Do you have to remove the slave cylinder from a 2004 f150 by removing the tansmision?
Yes , the slave cylinder for a HYDRAULIC clutch is inside the manual transmission bellhousing. It slides over the transmission input shaft and is bolted to the transmission
Where clutch Slave cylinder is located?
The slave cylinder for your hydraulic clutch is located inside the manual transmission bellhousing
Does a 95' ranger have a cable or hydraulic clutch?
Hydraulic and the slave cylinder is in the bell housing.
How to bleed a rover 400 with a sealed hydraulic clutch?
the easiest thing to do is remove the slave cylinder then pump the pedal and the fluid will pour out
How do you replace slave cylinder on 2005 Pontiac sunbird?
Remove hydraulic fluid line from slave cylinder (you may need to use a flared end wrench). Make sure master cylinder does not go dry!!! Unbolt slave cyliner from tranny, bolt new part on. Install hydraulic fluid line. DO NOT OVERTIGHTEN. Properly bleed system. Now your finished!
