Want this question answered?
The 1994 Pontiac Grand Am ignition lock cylinder is held in place by the retaining ring at the top of the cylinder. Remove the retaining ring. Remove the wiring harness from the back of the cylinder.
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
You can replace the ignition lock cylinder in your 1994 Pontiac Firebird without removing the steering will. Remove the retaining ring at the top of the ignition cylinder. The ignition cylinder will slide out.
In 1994 the 2.3 L 4 cylinder and the 4.0 L V6 engines are DIS ( distributorless ignition system ) The 3.0 L V6 was from 1995 on
screwdriver or punch
rip it out or call a locksmith it happened with my 94 tbird
The 4 cylinder engine is 2.3 liters ( 140 cubic inches ) in a 1994 Ford Ranger
Should be correct
if it has a distributor you can.
remove the shroud covering the steering coloum and turn the key to the on position push in release pin over ignition and pull cylinder out.
This makes no sense. What is your question?
should be red and light blue from the ignition switch to the starter relay