Want this question answered?
to remove the ignition switch from a 72 Chevy first remove the steering wheel, then remove the three screws that hold the turn signal assembly the turn signalhandle will unscrew if there is no cruse control if there is the handle will have a screw holding it in place this must be removed under the turn signal assembly there is a screw usually a #27 torx remove this and your ignition switch will slide right out
BAD IGN SWITCH
Yes, but you will need to remove any ballast resistor or resistance wire going from the ignition switch to the + side of the coil and replace it with copper.
Once you remove the dash plastic surround, you will find two bolts that hold the column up into the dash. As you loosen these bolts, the column will drop into your lap. I hope this helps you. Mark
Pickup on 101 - 1972 is rated/received certificates of: USA:PG
assuming the battery and cables are good and connected....check the ignition switch..:)
start by loosening the set screw on the knob. it is very small, so dont loose it. then take of the retaining nut and you can take the switch out from the back of the inst. cluster.
No a 1972 Chevy pickup is not the same model as a 1973 Chevy pickup. I believe it goes from 1967-1972, 1973-1980, 1981-1987. Doors will work from 1973-1976, 1977-1987. You would need to find 1972 doors as they are the only ones taht will fit a 1972. 1967-1971 are the same but there is something different about 1972 doors.
Unhook the battery pull switch out to headlight on position reach under dash to switch , will be a small button on it , push the button at same time pull on switch knob the know and stem will come out use a wide bladed driver and remove the nut that holds the switch in from front of dash unplug wiring remove
YES you do.
PartsTrain sells a wide assortment of parts for Ford pickup trucks. The 1972 Ford pickup is one of a wide range of Ford trucks that PartTrain covers.
Behind the dash, on the headlight switch itself, there is a "pin" that you have to push in in order to pull out the light knob. Feel under the dash, the pin is toward the back of the switch. When you push it in, with your other hand, move the light knob in and out. It will come out. Then, you can remove the nut, take the switch out from behind the dash.