0
I've done this twice in the past year. Remove the two screws under the steering column that hold the cover in place. Then you will see two nuts with washers, one on either side of the column, that hold the column to the dash frame. Remove those two nuts and washers, and you can lower the steering wheel and column to rest on the drivers side seat cushion. Then with a ratchet and I think a 5/16-inch socket and a couple of "wobble end" extensions on the ratchet, one long and the other short, you can contort your body into position to reach the two hex-head self threading screws that hold the ignition switch to the column. Once they are out, you can re-contort your body so that you can disconnect the two electrical plugs that connect to the right side of the switch. (When you first look at the plugs and the wires, it looks as though it is all one plug, but it's two.) Good luck!
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How doi remove ignition without key from 1986 Toyota pickup truck?
Begin by removing the retaining ring at the top of your 1986 Toyota pickup truck ignition switch. The ignition switch will slide out. Remove the wiring harness from the back of the ignition switch.
How do you remove an ignition switch from a 1979 Chevrolet C10 pickup?
Remove the retaining ring from the top of your 1979 Chevrolet C 10 pickup truck ignition switch. Slide the ignition switch out and remove the wiring harness.
How do remove the ignition switch on 1978 Chevy truck?
High-powered explosives.
My 95 dodge will start drive and then not turn off. I can remove the key switch the key back to accessory etc and the truck will remain on. is this an ignition switch issue?
Do you get a NO BUS That lights up on your mileage light?
How do you remove a stuck cassette from a 1995 dodge pickup?
YOU simply shut off the power switch to the radio and then turn off the ignition switch and when you restart the truck it should come out as long as the radio power is off
How do you remove the ignition switch cylinder to replace it on a 1971 Chevy truck with no key?
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.
Where is the vacuum switch on the front axle located?
On a Dodge truck, the vacuum switch is on the transfer case.On a Dodge truck, the vacuum switch is on the transfer case.
How do you remove the ignition key switch on a 1998 Chevrolet truck?
Removing the ignition key switch from a 1998 Chevrolet truck is a relatively straightforward process. Before beginning it is important to make sure that the truck is off and the battery has been disconnected. To begin you will need to remove the steering wheel by first removing the center wheel nut with a 12" socket and wrench. You should then use a steering wheel puller to remove the wheel. Once the wheel is removed the ignition key switch will be visible in the center of the steering wheel. To remove the ignition key switch you will need to remove the retaining clip and then unscrew the bolts securing the switch in place. After the bolts have been removed the switch can be removed and replaced with the new one.
How do you change the ignition switch on a 2004 gmc 1500 sierra truck?
how to remove cover to replace ignition lock cylinder and what type of tools do i need
How do you remove ignition switch 1966 ford truck?
remove the silver ring that is on the dash buy turning it with channel locks, it should be threaded
How do you install ignition switch 1988 gmc truck?
You need to remove the steering wheel first with a puller. There is a latch you can trip with a small screwdriver that will let the ignition switch slide out. Simply replace the switch and put the steering wheel back on.
How do you remove a 1975 dodge truck ignition switch?
If it is an in dash ignition switch, you just unscrew the ring on the front of the dash and pull it through the back, unhook wire harness and there you have it. there is a little brass colored button on the side that you push in with a small punch and the cylinder will slide right out, then slip in another for around $9 2 keys included.
