answersLogoWhite

0


Best Answer

I have a 98 neon and you take out the 3 screws on the underside of the steering colum .this take off the cover so you can see everthing.you will see a coulpe of screws that hold it in place ,unplug the wires and unscrew it .

User Avatar

Wiki User

โˆ™ 2006-04-23 20:10:13
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the ignition tumbler on a 1998 Dodge Neon?
Write your answer...
Submit
Related questions

How do you remove ignition tumbler 1998 Ford Mustang?

How do you remove ignition tumbler 1998 ford Mustang?


Remove ignition cylinder?

key switch tumbler removal on 1998 astro


How do you remove and replace ignition switch for a 1998 Dodge Grand Caravan?

Remove the plastic 2 piece shroud around steering column so as to gain access to the housing the tumbler sits in. Find three Phillips screws to remove in holes in the lower piece. Turn the ignition key to the Run position. Insert a small tip screwdriver in the access hole on the bottom of the housing to push the spring-loaded tab which will free the tumbler so you can simply pull the tumbler out with the key. Installation is the reverse. Be sure tumbler with key inserted is set to the Run position. Depress spring-loaded tab, insert tumbler into housing hole with tab down. All the way in, turn key to the Lock (off position).


Ignition switch will not turn on 1998 Chrysler concord?

tumbler has slipped. hit key with mallet . but ignition keylock will soon have to be replaced


How do you remove the ignition switch on a 1998 VW Jetta?

start by removing the shroud around the column. remove the assembly that houses the ignition switch, there is a spring catch located in the lock and tumbler, you will have to drill a small hole in the side to push this spring and while pushing the spring down rotate the switch and pull out.


How to Remove a 1998 BMW z3 ignition switch?

Begin by removing the retaining ring at the top of your 1998 BMW ignition switch. The ignition switch will slide out. Remove the wiring harness.


Does a 1998 dodge ram have a separate ignition and door key?

Not from the factory.


How do you change ignition switch on 1998 Buick century Do you have to remove the steering wheel?

do I remove steering wheel to change out ignition


How do you check ignition switch in a 1998 Toyota 4-Runner?

I have the same problem, going to have a locksmith make sure its the ignition switch and cylinder and just not a key problem or a tumbler problem.


How do you remove the ignition switch on your 98' Chevy lumina ltz car?

You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.


How do i change the ignition module in a 1998 suburban?

Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.


How do you get the heater core out of a 1998 Dodge pu?

Remove the dash!


Is there a kill switch on a 1998 dodge neon sport?

No, there is no kill switch except for the ignition switch.


Where is the ignition ballast resistor on a 1988 dodge Dakota 3.9?

A 1998 Dakota does not have a ballast resistor.


How do you remove spare tire on a 1998 dodge ram without tool?

To remove the spare tire on the 1998 Dodge Ram, you will need a hex tool. Apparently no tools came with the vehicle to do this, so you may end up purchasing this tool. Better yet, take it to a Dodge dealership and they can remove it for you.


Replace ignition wire set on a 1998 dodge stratus Es 2.5L?

To replace the ignition wire set on a 1998 Dodge Stratus ES 2.5L, you must first disconnect the wires under the instrument panel. You would then hook it up in the exact same order.


How do you replace starter on 3.3L 1998 Dodge Grand Caravan?

Remove negative cable from battery Disconnect positive cable from starter and ignition wire Loosen mounting bolts from starter Remove starter Install new starter in reverse order of removal


How do you remove a radiator fan clutch from a 1998 dodge Dakota?

Does anyone know how to take off a radiator fan clutch from a 1998 Dodge Dakota 3.9 V6


How do I change the Fuel Pump on a 1998 Dodge Durango?

Remove fuel tank for access


How do you replace headlight on 1998 dodge truck?

Do you have to remove the battery and battery holder?la


Do you need to remove the serpentine belt to replace the thermostat in a 1998 dodge ram 1500?

no


How do you take apart the dash on 1998 dodge ram?

To take apart the dash on a 1998 Dodge Ram, you need to first remove the bezel. From there, you remove the radio. Then the screws will come undone from the sides and under the dash. Then it just pops off.


How do you change the water pump on a 1998 dodge caravan?

remove front of engine and remove timing belt It runs the pump


How do you remove and install a 1998 Honda Odyssey Ignition lock and cylcinder?

very carefully reme it and remove plug and reverse the pro cesure


Where is ignition coil on a 1998 Honda CR-V?

Inside the distributor - remove the cap and you will see it.