The arm is held on by a c-clip on the steel post that serves as the hinge and mounting point to the side of the seat. Simply stated, you pop that clip off and pull the armrest out, then slide the new one in and replace the clip. This sounds much easier than it is. In order to get to the c-clip you have to partially remove the seat cover. Reach up under the back of the seat and disconnect the plastic clip that holds the seat cover together at the bottom. Then you have to peel back the cover (mine's leather - a real challenge) until you can jam your hand up far enough to find the c-clip. Don't be afraid to really yank on the leather or fabric...it's tough. An upholsterer could probably do this in 15 minutes. It took me an hour and I was hot and tired when it was done. Good luck!
remove the inner door panel, you can access the bolts from the inside of the door.
It is inside of the fuel tank. You will have to remove the tank to service it.
Remove the tire and wheel from your 1999 Chevrolet Suburban. Remove the brake pads and break assembly. Tap on the rotor with a hammer or mallet. When the rotor is loose it will slide off.
with a brick
How to remove the window motor from the regulator
Located in fuel tank Probably have to be removed
NO. It would be easier to just remove the transmission.
About 3 hrs. To take it out.
Yes you do. The distributor must be removed.
Should be able to remove the inspection cover and look at it.
Located in the fuel tank - may have to remove for access
yes the underpart of armrest has a bracket and single screw at end removing bracket screws will allow removal of armrest