You will need: Set of Spline screwdrivers, Flat screwdriver, Pop rivet gun, 3 small cable ties, Drill and 5 pop rivets.
1. Pull off the tweeter cover on top of door panel near front of window, no need to disconnect wire, just let it hang down.
2. Pull off SRS badge and remove the spline screw behind it.
3. remove the door latch plastic cover (1 screw)
4. At the bottom of the door pull handle next to the armrest there is an oblong slot, insert a flat screwdriver and prise the top half off, it is just clipped in. there are 2 spline screws behind it, remove them.
5. Using a plastic wedge of some sort or just by hand and starting at the lower part of the door latch, prise off the lower half of the door panel there are 6 or 7 plastic clips which hold it on, (I did this by hand and without breaking any but it may be worth purchasing a few just in case)
6. Lower the window and while pulling the panel slightly towards you, use your other hand to pull the panel upwards from the top starting at the front end, (this is quite tight, but it will come up)
7. panel is now off, pull the plug from the window switch and disconnect the cable from the door handle by opening the handle slightly and pulling up on the hook, the cable can then be removed from the door panel insert.
8. Drill out the 3 pop rivets holding the air bag and the 2 pop rivets holding the lower window strut. do not disconnect the airbag, let it hang down or tie it out of the way.
9. Remove the 3 screws holding the door latch and disconnect the wire from the panel near the front of the door. ( I actually cut the wire and pulled it through the loops to keep the original cable ties in place, when I replaced it I just used new cable ties to attach it back to the original location.)
10. You can now remove the locking mechanism by pulling it down and then towards the front by pushing back on the window strut.
Now do everything in revesre..
You will need to remove the dashboard panel in order to replace the electronic throttle control light. With the dashboard panel removed the light can be access to be replaced.
The electronic shifting was not introduced to the ML line until 2004. Model year 2000 still had a shifting cable attached t the transmission
hi there if i remember the distributor is troublesome and you have to replace the whole thing
can replace 1997e320 mercedes transmission with 2001
pull the heater control knob off and located behind is a small capless bulb pull out and then push in new bulb replace knob job done
If you have the automatic climate control system, I do not think there are actual "bulbs" in the display as it is all electronic. In my 1988 LeSabre I had to replace the entire control unit which I picked up at a salvage yard. Just a thought.
How do you replace 2005 Mercedes ml350 odometer fuse?
how do you replace the drive belts on an 1974 mercedes 230
How do u replace a hood release strap on a Mercedes c230
How do you replace the bulb in the mirror of a 2000 E320 Mercedes
How to replace front brake pads on Mercedes s430
Pull the glovebox and pull to the left and forward on the ECM...comes right out