On a 2005 Mazda 3 2.3L is easier if you lift the car from the front driver side, remove the tire and the plastic that covers inside the fender, the side that goes to the front of the car. if i'm not wrong i think it does have 3 bolts, two easy and one tricky one but it can be done with ease
It is located under the Intake Manifold. You must remove the intake manifold to get to it.
Below the intake behind the alternator.
Yes, you can go to Mazda and they should be able to get the part in for you.
The EGR is right under the throttle body. It has like a little black top. You have to remove the intake hose to see it. Its a pain to get to and remove.
tip lemon juice on it innit
To remove the shift knob on a '95 Mazda MX-3 just twist the knob itself counter clockwise until it comes off!
The intake air temperature sensor is located on the mass air flow sensor on the intake. There are five wires attached to the sensor.
You have to remove the intake plenum air chamber to get to the 3 plugs against the firewall. It requires to buy intake plenum gaskets and go ahead and replace the PCV hose on the back of the plenum. Need to get from the dealer. Gaskets also from dealer.
Underneath the intake manifold. If you remove the front right wheel, you'll see it up behind the fender. For owners with thinner arms, you could remove the oil filter from the engine bay, reaching under the intake manifold.
what is the tork for the intake(bolt 8mm) v6 3l 2001 Mazda tribute es
remove the intake up to the throttle body. after that you should be able to see the coils on the drivers side of the engine. remove the bolt and replace. don't mix the ignition wires.
Disconnect the battery, remove the intake manifold, remove the spark plug boot covers and cables, and remove the old spark plugs. Put in the new spark plugs, attach the spark plug boot covers and cables, replace the intake manifold and connect the battery.