Want this question answered?
There are several warning lights on a 1997 Grand Am. Some of the warning lights are the ABS system, oil lights, and the check engine light.
The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.
You must first remove the trunk door facia. (This is the part with the "Pontiac" lights in it.) Then you can get to the bulb to replace it.
Remove the wiring harness from the back of your 1997 Ford Crown Victoria hazard lights switch. Remove the hazard light switch retaining screws. Reverse the process to install your new hazard light switch.
Yes, there are about 6 bolts on each side you have to remove, you do not have to remove the molding, just use the access panels, however you have to pull the center part out, (3000GT part) a bit to remove the tail light.
My rear window brake light works, but not my tail light brakes on my 1997 Monte Carlo. What is the problem?
The dashboard lights on a 1997 Eagle Talon can be changed by reaching up into the dash to get to the bulbs. Another way is to remove the dashboard screws and remove the front of the instrument panel.
The light bulb unit is found underneath the carpet behind each tail light area. Remove the plastic screws holding the trunk carpet to the interior sides behind the rear lights, follow the wiring to the center of the tail light, this is the light bulb unit-unscrew and remove.
Brake light fuse
You dont actually remove any panal. In your trunk should be some bolts, either plastic type, or metal, right behind the tail lights. These need to be removed. Once removed, you can wiggle the tail light off the car, and replaced the affected tail light bulb.
1997 dodge ram 1500 tried head light switch did not work.head lights and running lights do not work at the same time.
take the three or 4 Phillips screws out of the taillight, remove the light assembly and replace the bulb......all with the tailgate up of course.....