For the rear plastic one, insert a thin blade screwdriver in the slots(two on each side of the frame about 1" from the top/bottom)and push back the tab while applying pressure to pull the frame away from the license plate. There are 4 snap tabs on the frame that just need to be pushed back to disengage from the body slots. Be carefull, they're not very sturdy. This was from another reader, It worked great. Thanks
A person can remove the front license plate cover on a 1990 Corvette with a screwdriver. The plate can then be replaced with a custom plate or a state plate if required.
There are screws holding it on. Un-screw them.
1980 corvette , how to remove speedometer
I need info on how to remove the climate control unit from my 1998 corvette.
The 1996 corvette does not have a T Top.
Remove the inside door panel of your 1982 Chevy Corvette. Remove the window retaining clips. The window will lift out.
To remove the egg yolk you must pierce a small hole in each end of the shell with a pin then blow into one end, the egg will come out of the shell without breaking.
Drain the water from your Corvette radiator. Remove the radiator hoses. Remove the radiator stabilizing arm bolt. Remove the radiator retaining bolts. The radiator will come off.
how do i remove the dashboard from my 2002 corvette to change the hud display there is a site that may help you www.spdkilz.com
remove the license plate and reach up through that opening. Corvettes weren't designed to be easy to work on.
Remove the retaining ring from the top of your 1989 Chevy Corvette ignition switch. Slide the ignition switch out and remove the wiring harness.
what year corvette? try searching the forums at www.corvetteforum.com - they have TONS of answers
If it's like my 88 remove license plate, remove wire to backup light, pull backup light assembly straight out (sideways), reach hand to taillight socket, twist socket and remove.
To remove the seats from a 1995 Corvette, you will need to remove the front and rear nuts from the seat frame studs. You will?æalso need to remove the lug wrench that is attached to the seat frame studs.
with a sledgehammer.
There are two screws on the bottom of the cover. You should have just enough room to fit a screwdriver in between the nose of the car and the cover without scratching the paint. It might be tight, but the cover should give enough for you to get tools in there.
How to remove rear wheel bearings on a 1978 corvette..?
Remove four bolts. Lift it out.
Remove license plate, dissconnect backup light wire, remove bolts to backup light, pull backup light sideways, reach hand to tail light, twist socket.
how do you remove a radio from 1987 300d Mercedes also why do we get cracking sound from speakers with radio shut off.