Chevy Corsica
Chevy S-10
Ford Expedition XLT
Ford F-250

How do you remove the oil sending unit on a 1990 Chevy Corsica 3.1 ltr?

212223

Top Answer
User Avatar
Wiki User
2015-07-15 19:46:36
2015-07-15 19:46:36

unhook the wire, screw the whole sensor out then thread the new one in and hook up the wire

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The gas tank on a 1990 Chevy Corsica is 15.6 gallons. A 1990 Chevy Corsica takes unleaded gas not premium.

User Avatar

Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?

User Avatar

Drain the water from your 1990 Chevy Corsica cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.

User Avatar

Place something to catch the engine coolant beneath your 1990 Chevy Corsica radiator. Remove the radiator drain plug with a 9/16 ratchet. The engine coolant will drain out.

User Avatar

Some bulbs can be changed by accessing them through the runk but I think your have got to remove the light assy and then remove the bulb.

User Avatar

under the kick panel passenger side

User Avatar

The AC system can be recharged in a 1990 Chevy Corsica by connecting a refrigerant tank to the low pressure inlet. Refrigerant is then added until the correct pressure is reached.

User Avatar

The 1990 Chevrolet Corsica TCC transmission solenoid is located on the top of the transmission. The solenoid will be near the back of the transmission.

User Avatar

where do most federal government dollars come from

User Avatar

Too my knowledge there is no such animal. Describe the part and what it does, where it is located.

User Avatar

side of the dash under a panel as you open the drivers door

User Avatar

on the drivers side just under the exhaust manifold

User Avatar

where are the temperature sending unit located on a 1990 Chevy engine 5.7

User Avatar

how do you remove the ignition switch on a 1990 chevy half ton pick-up?

User Avatar

You must drop the fuel tank in order to replace the fuel pump.

User Avatar

If the engine is either a 2.5L 4 cylinder engine or a 2.8L 3.1L V6 it should go in.

User Avatar

If the car has a 3.1 or a 2.8, the sensor is located right next to the oil filter, to the right about 1 inch.

User Avatar

u have to drop the tank. its pretty easy. the new pump will bypass alot of the old conections.

User Avatar

depends what parts u need but the Pontiac tempest is almost thE SAME.

User Avatar

It is right behind the distributor, screewed into the top of the engine block.

User Avatar

frist remove turn signal/marker lights then remove grill from rad support.

User Avatar

Begin by removing the decorative cover from your 1990 Chevy Caprice factory radio. Remove the radio retaining screws. Remove the wiring harness and the antenna cable from the back of the radio.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.