0
How do you remove the panels around the steering wheel in order to remove the radio '99 Sephia?
Wiki User
∙ 18y ago
Go to www.kia101.com it has a tutorial on a CD player install.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you remove fuel pump on 1996 Kia Sephia?
how to remove fuel pump on 1996 kia sephia
Where is the flasher on a 1995 Pontiac Grand Am?
the flasher is located in the steering coloumn. you have to remove the kick panels on the drivers side to get at it
How do you rerplace turn signal stalk?
You have to remove the upper and lower panels from the steering column, remove the bolts that hold the stalk in place and unplug. Install in reverse order.
Where is the signal flasher for the 1992 Chevrolet lumina car?
Just to the right of the steering column, close to the fire wall. Remove both plastic panels beneath the steering column to be able to see it.
How do you remove back seat from a 1998 Kia Sephia?
removal 1998 kia sephia back seat
How do you remove ignition switch on 1991 Mercury Topaz?
You have to remove the top and lower panels around the steering. From then, you will see the ign. switch. remove the wire harness. The switch has to be in a certain position for removal. Has been a long time since I have done one. So, any other input from someone might help.
How do you replace the ignition switch in a 92 Chevy Cavalier?
We just finished doing this job so I hope this helped. First and foremost, disconnect your battery. You do not need to completely remove the steering wheel. First you do need to remove the panel that contains your horn (you will have to disconnect it as well). Then remove the 6 screws from the steering wheel. Remember the position your steering wheel was in so you do not mess up your alignment in the process. After that, you will remove the top and bottom panels behind the steering wheel. There should be 3 screws holding the bottom panel in. Remove those. You will also need to remove the handle on the left hand side of the steering wheel that adjusts the height of the steering wheel. It screws off. There will be two screws, one on either side of the steering wheel that connect the top and bottom panels together. Remove those. The panels should come apart fairly easily after this. Remove both of the panels. The ignition switch will be on the bottom left side of where the steering wheel was. It is held in by two screws and have two sets of wires coming out of it. Remove the screws first as this will allow you to remove the wires easier. Remove the two sets of wires. After this, take your new ignition switch and reverse the process: put the wires back in, put the screws back in and secure it in place (Before you put everything back together, temporarily reconnect your battery to make sure everything works. Disconnect your battery after the test and start reassembling.), replace both of the panels and screw in the two screws that hold the two panels together, put the three screws under the bottom panel back in place, put the steering wheel back on in the same position that you took it off and screw it back in place, reconnect your horn and put the panel for the horn back in place, and screw the handle to adjust your steering wheel height back into place. Reconnect your battery. After that, you should be good to go.
Where are the fuse panels located on a 2001 Camry?
It's behind the comparment on the left hand from the steering wheel. You have to remove the compartment in order to get access to the fuse panel.
Where is the fuse panel located on a 1999 Buick LeSabre?
Look under the dash board on the driver's side near the steering columnMay have to remove plastic panels for access
How do you remove washer pump?
where is the washer pump on a kia sephia 2000
How to Remove power steering pump on mystique?
Remove the power steering pump hose. Remove the power steering pump belt. Remove the power steering pump retaining bolts. The power steering pump will come off.
How do you replace an ignition switch located on a 1987 Cadillac Fleetwood?
It is located on the left side of the steering column. You will have to remove panels underneath the dash- as well as some ductwork to gain access.
