its not a simple thing to do..first thing you need is a manual for your car..it will tell you everything you need to know..you will need a air impact gun with the proper impact socket or the special wrench to hold the crankshaft pulley from turning when you remove the bolt with a breaker bar...this usually takes two people if you don't use an impact gun. Not a job for a novice or first timer
It is located behind the plastic splash shield in the left front wheel house. If you are looking at the left front wheel the proportioning valve is located at approximately the 2:00 o'clock position of the wheel behind the splash shield.
Go to a parts house and purchase a Haynes Manual that is specific to your car.
They Open at 7:00 am
Color Splash - 2007 Mountain Guest House 4-6 was released on: USA: 20 September 2008
z motor? remove valve cover and use straight edge on back of head with groove in camshaft then use dowel tool for crank. kit can be rented from parts house...base timing is not adj. only aligning timing belt is necessary
A fridge or something that you can see is plastic coated or fully plastic
House Hunters International - 2006 Making a Splash in Marbella Costa Rica 55-8 was released on: USA: 8 August 2013
plastic
Jack the front up, take off the drivers side wheel/tire, remove the plastic wheel house liner 6 screws (you will see), remove negative terminal, remove positive terminal, remove bracket that holds battery, reverse order to install.
To safely remove a mud dauber nest on your house, wear protective clothing, approach the nest at night when the wasps are less active, use a long-handled tool to knock down the nest, and dispose of it in a sealed plastic bag. Be cautious and avoid getting stung.
The water pump is bolted to the engine block underneath the plastic covers that house the valve timing belt, camshaft and crankshaft gears, idler pulley and spring tensioner. The timing belt must be removed to access the water pump. This is not a job for a novice to attempt. Usually it is recommended to change the timing belt and water pump at the same time.
You can use plastic window insulation to conserve energy around the house. It acts as an extra sealant to keep the temperature of the house at a constant.