0
How do you remove the primary drive chain on a Harley Sportster 883 to change the stator?
Wiki User
∙ 16y ago
Take the rotor and the clutch basket off at the same time
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you change the battery in a 95 harley Davidson sportster 883?
Remove the Seat.
81 Harley Sportster primary case oil capacity?
remove the round derby cover from the primary. fill until the oil tries to run out. replace the cover.
How you remove the oil tank from a 1989 Harley Sportster?
how to remover oil tank 1988 sportster
How do you change the primary oil on a Harley?
locate and remove your primary oil drain plug, once the fluid is removed,remove the derby cover and replace the primary fluid to the approiate level
Where is the drain plug on a 2005 harley-davidson sportster 883?
There is a Hose with a Clip attached to the Left Side of the Frame underneath the Primary Cover. Remove the Clip and Pull the Drain Plug in the Hose..
How do you change spark plug wires on a 1993 Harley sportster?
remove one at a time follow it to where it goes and pull it off and do the same with the other one. this is very easy no tools needed
Where is the primary drain plug on a Harley Sportster?
On a 1986-2003 there is a drain hose. Look under the motor and there is a rubber hose with a worm clamp on it, it attaches to a bung on the frame. Loosen the clamp and remove the hose from the bung.
How do you remove Harley Sportster front fender?
On my 06 I just removed the two nuts & bolts on each side & slid it out.
Remove and replace the shifter shaft sportster 1998 harley Davidson?
good instructions in the manual. I just removed mine to have it welded.
Where is the odometer fuse on a 2001 Harley Sportster?
Next to your battery you will see a triangle shaped cover with 3 screws in it, remove that to access wiring, fuses, etc.
How do you change a belt drive on a 1993 sportster 883?
If memory serv's you will need to remove your rear brake master cylinder and reservoir. Then remove the access cover. You will also have to remove the rear axle to get the drive belt on. I would advise that if you are going to DIY your bike you purchase a service manual from your local Harley Dealer.
How do you remove the primary cover on a Harley Sportster?
Remove the derby cover on the back end of the primary cover. Behind it you will find a spring and nut. Both slide off. Remove the nut behind that. You have to turn the screw inside it to get it out. remove the bolts from the primary cover and pull if off, AFTER you drain the oil. Once you are done, install the cover and put the first nut back on and turn the screw, just until it bottoms and then back out about 1/8 turn. Put the other nut back on and the spring. Put in your oil and install the cover.
