Caution:On models equipped with Delco-Loc 2 or Theftlock audio systems make sure you have activation code * Disconnect the negative battery cable * Drain the cooling system * Disable the airbag system.Disconnect the forward discriminating sensor harness from the front fenderwell.It may be necessary to remove the hood latch mechanism in conjunction with the airbag sensor and secure them together and out of the way during the radiator removal * Remove the cooling fan assembly * Disconnect the upper and lower radiator hoses from the radiator then disconnect the coolant recovery hoses at the radiator neck * Remove the automatic transaxle cooler lines if equipped from the left tank of the radiator * Remove the hood latch support from the upper tie bar on the front of the engine compartment * Remove the right and left headlight assemblies from the vehicle * Remove the condensar mounting bolts from the radiator assembly * Remove the tie bar (crossbeam) from the engine compartment * The radiator can be removed from the top with some wiggling to clear various components
On top of the reservoir on the passenger side of the motor. It will say Caution do not remove when hot!. There is not one located on top of the radiator itself.
use a very long flat head screw driver with a hammer and a pair of plyers
I need to know how to remove a rear wheel speed sensor on a 2002 Pontiac Sunfire
With a sledge hammer and a bottle of febreeze
The center console is held on by several mounting screws. To remove it from a Pontiac Sunfire unscrew all of the mounting hardware. The center console will then be able to be pried off.
yes
Remove the transmission oil pan
The 1997 Pontiac Sunfire front bumper is held in place by six retaining clips and for retaining bolts. Remove the retaining bolts and pry outward on each retaining clip.
To change the reverse lights on a Pontiac Sunfire you need to locate it on the left side of the transaxle. Then, unplug the electric connector and remove the switch along with the socket.
On the 2.2L(2200), the oilstick is built in as part of the cap that you would remove if you were putting oil in the car. This cap is located on the side of the motor, right behind the radiator.
Remove the front bumper fascia.Unplug the horn electrical connector and remove the bracket bolt.
Don't know, would like to know.