1) Open cup holder under the stereo.
2) Pry off small panel just above the cup holder which is the same color as dash.
3) Remove the 2 screws that were exposed.
4) Gently pull panel from the dash from the place where you just removed the screws
5) As you pull the panel out, you will release a bunch of clips. Move the panel off to the side.
6) Now you can see the screws holding in the stereo and CD changer. Undo these screws and it is out.
first you have to remove the panels in front. Now in my van there is a small compartment under the main panel, for storing cds ect. Slowly jiggle it back and forth until it moves to the side, once freed you can now use a flathead screw driver and gently loosen the clips on the panel and once it starts to give pull gently downward and it should pop off. Once that is done then go ahead and remove the screws holding the radio in place, and once done the radio should slip out, disconnect the wires, and you are now finished the removal. Hope that helped.
You will need to remove the 2000 Ford E2 50 radio retaining cover. Remove the radio retaining screws. Remove the wiring harness and antenna cable from the back of the radio.
if its the sound 10 or 20 go halfords or stereo shop and buy kenwood European removal keys put them hooks facing together in slots in bottom corners and it slides right out
in the 96 van, the radio fuse is number 11 and is a size 15 in the 96 van, the radio fuse is number 11 and is a size 15
go to WWW.the12volt.com and you can figure it out from there
The theme music was "The Shuffle" by US band Van McCoy
inside of van in vicinity of heater core. to remove, remove battery from engine bay to access bolt that holds it in place
From the 1994 Ford Econoline Owners Guide #8 radio memory, 15 amp fuse. #11 radio and clock, 15 amp fuse. #14 power windows, 20 amp circuit breaker.
would like to se diagram of strut assembly on venture van diagram
How do you change rear brake drum on a 2004 Chevy Venture?
Ask a 4-year-old to help you.
yes
owners manuel
my heater fan in front of my 2004 chevy venture van wont work
under the van, in the center.
Remove the 3 screws and pull the ring down -really hard-
under the hood. Hi, If you are looking at the engine from the front of the van, the reservoir is on the left side, toward the back of the engine. It is easier to get to if you removed the windshield wiper shield. I have also included a link that shows where it is on a 2001 Venture, but it is the same for the 2004 Venture. Look for the Red lettering on the cap. Good Luck, Greg
first you have to take the wheels off of the van,and then you have to take the tension off of the brake shoes. Next you will be able to remove the rear brake drums off of the vehicle.You may have to tap them with a hammer to break them free.
The 2004 Chevy Venture has the most common hook-end arms. See related links below for install video. Press the tab or button which is located where the wiper blade is inserted into the hook and pull the wiper blade out of the hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
Park it in the Mexican part of town with Mariachi music playing and they will remove it for you.