Want this question answered?
5 litres
4 stroke
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing retaining nut. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
You need to refer to the service manual to remove a 2000 Ford expedition XLTS key-less entry system.
to remove the spindle and four bolts hold the bearing assembly to the "A" frame. remove the wheel, remove the control arm, remove the lower "A" frame , and remove the CV axle. then you will have acess to the 4 bolts that hold the bearing assembly. you will have to buy the whole assembly.
What causes the generator to burn out after replacing the alternator
The chain on a 2000 Polaris Trail Boss 325 is removed by loosening the retaining bolts and applying tension away from the sprockets. The chain can them be slipped off the sprockets and removed.
Remove wheel then remove the big nut that holds the axle to the hub. Remove the brake caliper and rotor, through the hole in the face of the hub(where the wheel studs are) remove bolts that hold the hub and bearing to the steering knuckle. Tap hub and bearing assy from knuckle. The hub and bearing is one part.
2000 polaris magnum 325 2x4
go to strutmasters.com
Polaris SnoCross happened in 2000.
Begin by removing the tire and wheel from your 2000 Mitsubishi. Remove the end of the axle. Remove the wheel bearing nuts. Remove the axle seal and the wheel bearing. Reverse the process to install your new wheel bearing. It will take a novice mechanic approximately 2 hours to complete the job.