Want this question answered?
Can you show me pictures on a dodge neon 1998 on how to remove and replace a front axle.
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing retaining nut. Remove the axle seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
To change the rear axle fluid you can remove the rear cover from the axle and drain it that way. If you don't want to remove the rear cover you can use a pump and a hose to drain it through the fill hole.
this should be easy to find but it isn't don't know why ! people that right on forums are to stupid to include ........ " remove the axle nut" correction = remove the axle nut using a 29mm socket! how hard was that !!!!!!! 29mm is what you need for that nut !
Remove the tire and wheel from your 1996 Toyota Tercel. Remove the end of the axle. Remove the wheel bearing seal. Remove the wheel bearing nut. Remove the wheel bearing. Reverse the process to install your new wheel bearings.
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
Remove the front tires, from your Pontiac Grand Prix. Remove the brakes and rotors. Unbolt the axle from the suspension. Remove the axle.
Yes you can, The axle will stay attached to the hub in that situation though. After the brakes are off you will see bolts on the rear of the knuckle holding hub on. Lossen bolts about 1/4 in. Using an old socket start to hammer on the bolts until the hub comes loose. This can be a challenge.
Yes, if you remove the front axle first.Yes, if you remove the front axle first.
Remove the tire and wheel. Remove the axle end cap. Remove the axle seal with a seal puller. Reverse the process to install the new axle seal.
1 11/16 inch
how to remove rear axle from 1988 f250 ford