I just acquired a 98 neon with the rear brakes locked up. Come to find out, they were just worn metal to metal. The easiest way to get the drum off is with a 5 ton pully puller. You can rent one from autozone for $40. Then take the puller back and get your money back. It's a little complicated to get it to stay on the drum until you get pressure on the jaws, but when you start turning the spindle it will pop the drum right off.
AnswerThe nut you mention is only for the bearing. To remove drum you will have to hammer on the sides of it until it loosens. I had to hammer pretty hard all the way around due to it being rusted on. Once you have it loose it will just slide off.brake drums should pull off if not rusted on.
there is a rubber plug on the bottom remove plug to adjust
Lift the car, remove the tires, remove the brake shoe/calipers, and remove the old brake pad. Put in the new brake pads, replace the brake shoe/caliper, replace the tire and lower the car.
How do you stop brake pulsation on 1998 dodge ram
You put brake fluid in the brake fluid reservoir on a 1998 Dodge Stratus. This is located on the master cylinder, under the hood, on the driver's side.
No.
The Dodge Shadow stopped production in 1994
disconnect the brake hose then remove the 2 10mm bolts and its off install in reverse and bleed the line
grab a mallot and bang it all around, as if u wanna hammer it in more
DOT 3
DOT 3
In the master cylinder.