just pull them off like you would with anyother brake drum you might need to give them a few taps on the back side with a hammer
The brake light switch is located on the brake pedal bracket. You'll need to remove the trim panel beneath the steering column to get to the switch and the connector. FriPilot
Brake drums can be a big pain in the behind to remove. If they've been on the car for some time, the brake shoes may have actually formed a groove in the drum where they contact it. It doesn't have to be real deep to keep the drum from coming off. You'll have to back off the adjuster star wheels to loosen up the shoes and get them to drop out of the grooves. If that doesn't help, don't be afraid to beat the living daylights out of the drum with a hammer. Sometimes that's what it takes to break them loose.Note that if your drums are badly grooved, you'll probably have to replace them, as there's a good chance that they are beyond resurfacing.
Lift car, remove wheel, remove caliper & caliper bracket (bolts in back near strut). Give the rotor a wack with a hammer if it's stuck on the hub and remove it. Reverse to install.
To change wheel cylinder on a 2000 Chevy Malibu, jack up the vehicle and remove the tires, brake drums and brake shoes. Spray the hydraulic line and fitting with CRC 5-56 and loosen hydraulic fitting. Remove the two mounting bolts and remove the wheel cylinder. Replace with new.
Remove wheel, remove dust cap, should be a castle nut with a cotter key, remove key and castle nut. if memory serves, the drum should come off now.
I need to know how to remove a rear wheel speed sensor on a 2002 Pontiac Sunfire
Remove the transmission oil pan
first you need to check your brakes 2000 vehicles dont have front drums, they have disk brakes
you have to remove the caliper to access the brake pads
remove wheel. remove brake caliper assembly(not the brake hose) and pull off the rotor.
* Remove the front bumper fascia * Unplug the horn electrical connector and remove the bracket bolt
On the drums there are two holes. You need to insert two to bolts (size 10 metric) in to the holes as yoo tighten the bolts it pushes the drum off. bolts need to be about 3 inches long. i could be wrong about the bolt size