Want this question answered?
Remove inside door handle and window crank handle, remove inside door panel, remove vent window and channel assembly, remove window.
Lift the door handle as though trying to open the door. You should see two pins going through the handle assembly. The pins can be pushed out, allowing you to remove the handle.
You will need to remove the inside door panel, by prying outward on the door panel retaining clips. When the door panel is removed the door handle assembly will be visible. Remove the door handle retaining bolts.
you have to remove the door panel to access the inner door and remove the entire door handle assembly ( from the inside). Once you've got the handle out, remove the lock cylinder, to access the broken key.
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
You will have to remove the entire door panel to get at the screws that hold the handle assembly to the panel.
you need to remove the inside door panel to get access to the inside, remove the clips holding the door handle assembly and the whole thing comes off
* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car
remove the interior door panel and you can get at the door handle, disconnect the rod and loosen the clips that hold it against the door, the whole assembly will come right out.
You must replace the handle, they are made of plastic. For the inner- remove both screws in the door panel[in the grab handle] remove the trim from the door handle. Remove window crank and with proper tool remove door panel. Tool is cheap. With panel off, there will be one rivet holding old door handle in place. Drill out rivet [ 3/16 ] and slide whole door handle assembly forward. Carefully remove door and lock rods and reverse the process to assemble. Outer- One bolt is behind door panel and the other is on the outside edge of the door right behind the handle. Simply remove bolts, remove handle and swap door lock into new handle and replace.
Remove the inside door panel of your 1987 Chevy. Remove the linkage from the door handle. Remove the door handle retaining bolts. The door handle will come off.
Remove the inside door panel. Remove the door handle linkage. Remove the door handle retaining bolts. The front door handle will come off.