Jeep Grand Cherokee
Jeep Grand Cherokee Laredo
Jeep Grand Cherokee Limited

How do you remove the rear lift gate trim panels on a 1997 Jeep Grand Cherokee?

161718

Top Answer
User Avatar
Wiki User
2007-05-01 14:26:57
2007-05-01 14:26:57

remove the obvious screws - sides - bottom - bottom of window glass. Then feel for 2 screws one near each lower corner of the fabric panel. The screws are well recessed. After that pull the panel at the lower sides it is held with plastic push in studs

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The engine computer is the voltage regulator in a 1997 Jeep Grand Cherokee.

User Avatar

A 1997 Jeep Grand Cherokee does not have EGR.

User Avatar

How do you change the orifice tube on 1997 grand Cherokee jeep with 5.2 v/8

User Avatar

It will bolt up, but it will not shift. 1997 is electric, 1994 is hydraulic

User Avatar

The center console will more than likely fit. However, i believe the door panels will be different. the switches have different wiring and buttons may be slightly off. grand Cherokees switched the interior styling in 96. it is hit or miss, but most things are compatible.

User Avatar

The only foolproof way is to remove the starter and bench test it.

User Avatar

A 1997 Jeep Grand Cherokee has one ignition coil.

User Avatar

most auto parts stores sell universal fasteners just remove the old ones and place in the new ones

User Avatar

Remove the wheel; remove the brake pads and caliper; the rotor should slide off of the lug bolts.

User Avatar

No, you will have to remove the tank.The 1993-1997 Intrepids where the only ones with access panels.No, you will have to remove the tank.The 1993-1997 Intrepids where the only ones with access panels.

User Avatar

The jack is located under the rear seat on my 1997 Jeep Grand Cherokee.

User Avatar

some are yes but the sensors have different connections

User Avatar

Wrangler up to 2006, Cherokee up to 2000. Grand Cherokee up to 2004.

User Avatar

How do you disarm the security lock on a 1995 Jeep Grand Cherokee Laredo?

User Avatar

I have a 1997 Grand Cherokee, and my key fits both the door and the ignition.

User Avatar

I know the Cherokee does. If the Grand Cherokee does, check the diagrahm on the fuse panel cover. or owners manual.

User Avatar

Yes. Both use the same lug pattern. They will interchange.

User Avatar

1997 Jeep Grand Cherokee Service Manual click here http://www.megaupload.com/?d=VNJ4PXVP

User Avatar

loosen the four nuts that hold clutch fan to water pump then remove serpentine belt then remove the loose nuts ,take fan from engine.

User Avatar

No, it will bolt up, but it will not shift. The 1995 is hydraulically controlled. The 1997 is computer controlled.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.