There is a bolt at the rearof the lower seat (in the centre) that holdsit in. Its normally hidden by the boot carpet and you may need to fold the seat tops down slightly to get to it too.
Fuel pump assembly is located inside the fuel tank. The access to it is under right rear seat.
The ecm is located under the front passenger seat on my wife's 2000 Daewoo Lanos. This is an American version of the car.
The fuel pump on a Daewoo Lanos is located inside the fuel tank. To access it, you typically need to remove the rear seat cushion and then the access panel beneath it, or alternatively, you may need to drop the fuel tank itself. Always ensure to follow safety precautions and refer to the vehicle's service manual for specific instructions.
To remove the back seat of a 2000 Daewoo Lanos, start by locating and removing the bolts or screws securing the seat bottom to the floor, usually found at the front edge. Once the bolts are removed, pull the seat bottom up and out. For the backrest, look for bolts or clips at the base or rear of the seat, remove those, and then lift the backrest upwards to detach it from the vehicle. Always consult the vehicle's manual for specific instructions and safety precautions.
YOu will have to remove the rear seat and the cover. This will make the fuel pump visible. Once you do this you will have to disconnect the two fuel lines and electic plugs. One you turn the lock, the fuel pump assembly will come out.
Access to they speakers is obtained by removing the rear deck lid sill plate cover. -lower the folding rear seatback -remove the center high mount stoplamp (if equipped with one) -remove the child seat tether anchor (again-if so equipped) -remove the plastic retaining clips on the deck lid sill plate cover and the speakers are right there.
The rear seat is not designed to be removed. You can remove the center seat and slide the rear seat forward.
there is a round put on the top corners of the seat. pull the pin up and simply fold the seat down. you will have to move the seat belt to the side to allow the seat to go down also.
Remove the bolts fastening the rear seat cushion (Figure 7.52).Remove the rear seat cushion assembly.Remove the screws and remove the side rear seat back (Figure 7.53).Remove the lower bolts fastening the rear seat back.Tightening torque - 17-26 NmFlip forward the rear seat back, remove the bolts and remove the back seat.Tightening torque - 17-26 Nm
The rear seat isn't designed to be removed. If you have a center bench seat you can remove that by unclipping it, then slide the rear seat forward.
The rear seat is not intended to be removed. You can remove the center seat and slide the rear on forward into it's place.
How do you remove the rear seat on a 2002 diamante