Want this question answered?
remove upper bolt shock remove swing arm nut, remove rear brake master cylinder, remove chain
The tail doesn't swing. The nose opens upward, or there is a cargo door cut in the fuselage on the left side behind the wing -The tail DOES swing, The 747-400LCF is a specially designed freighter to move haul parts of the 787 over large distances, this plane has an enormous cargo bay in the middle, and the tail section can be swinged open to load/unload large cargo.
Ye
** On the dutch door type ;glass hatch two lower doors swing out ** there are four screws one at each corner of the door panel and gives you access to the door interior and there is a plate covering the lock and it is much fun to fix it.. Al alco716@verizon.net
with a Phillips screwdriver
No
The cabin air filter on a 2003 Chevy 2500HD pickup is located on the passenger side under the glove compartment. To replace it, first remove the two screws on the kick plate under the glove compartment. Remove the kick plate. Then, unclip and swing the filter housing cover to the right. Remove the filter by pulling straight down. Insert the new filter, and reassemble in the reverse manner.
disconnect negative battery tml.,remove the plug from the alternator,remove the main battery wire from the stud on the alternator, remove the lock bolt, swing alternator down to remove belt, remove pivot bolt, swing alt. until its out. replacement is reverse of remova; To take out the alternator on a 88' tercel, you have to do it from under the car
# Open the rear cargo door. # Use phillip's head screwdriver to remove 2 screws on side of light assembly. # swing light assembly out away from vehicle. # twist the bulb bracket counterclockwise 1/4 turn. # pull out. # remove bulb. # replace bulb(s). # reverse steps to reinstall light assembly.
Bigger hammer.
Remove wheel. Remove brake caliber. Remove axle nut and brake rotor. Now at bottom of shock at swing arm (the V shaped bracket that connects to bottom of shock) there is a nut that holds the shock and swing arm together. Remove this nut. The swing arm should fall down with a tap of hammer. This will give u enough room to remove axle from upper shock assembly. You can then remove and replace the cv boot that will be held on with two hog nose rings. Reverse process to put nack together.
It's a GM