answersLogoWhite

0


Best Answer

To remove the tail light assembly on a 1987 to 1989 Chevy Celebrity:

On the inside of the trunk next to the quarter panel look for the nuts that hold the rear header to the body. Remove the middle nut, which will be in the center of the tail light assembly. the assembly will then pull outward. When the stud clears then pull to the outside of the car to release the tab from the back up light assembly. If you remove a nut but the tail light assembly did not budge then you probably removed the wrong nut.

I like to replace the original nut with a wing nut. That makes future removal easier.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the rear taillight on a 1988 Chevrolet celebrity?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel pump location on 1988 Chevrolet Celebrity?

The fuel pump on your 1988 Chevy Celebrity is in the fuel tank.


How do you adjust the timing on a 1988 celebrity?

The 1988 Chevrolet Celebrity uses distributor-less ignitions. Timing is controlled by the ECM, there is no provision for adjustments.


Does a 1988 Chevrolet Celebrity have rear struts?

No there are shock absorbers on the rear.


Where is the oil sending unit on a 1988 Chevrolet celebrity 2.8L v6 located?

The oil pressure sending switch on a 1988 Chevrolet Celebrity with 2.8L V6 is located on the bottom of the block near the oil filter.


Is the factory timing chain on a 1988 Chevrolet celebrity metal or plastic?

Metal.


What type of freon is in 1988 Chevrolet Celebrity?

R12 unless it's been converted.


How do you remove wiper blades from a 1988 Chevrolet celebrity?

you are the stupidest person in the world u dum azz if u want to fight about it than call 727 485 3342


Where is the oxygen sensor on a 1988 Chevrolet celebrity?

If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.


Where is the crankshaft sensor located on a 1987 Chevrolet celebrity 4 cylinder 2.5?

It on the back of the coil packs going into the side of the block.


What is the firing order for a 1988 Chevrolet celebrity with a 4cy?

The firing order for all of the Chevy Celebrity 4 cylinder engines is: 1 3 4 2


What does the timing need to be set on on an 88 Chevy Celebrity?

The 1988 Chevrolet Celebrity uses idistributorless ignition systems, the timing is controlled by the ECM. there is no provision for adjustment.


How do you remove the dashboard in a 1988 Chevrolet beauville van?

http://www.vannin.com/