answersLogoWhite

0


Best Answer

how to remove the starter from a 92 s-10 4x2 with a 2.8 engine

User Avatar

Wiki User

โˆ™ 2012-06-09 15:58:23
This answer is:
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How do you remove the starter from a 92 S10 blazer?
Write your answer...
Submit
Related questions

How do you take out the starter on a 92 S10 blazer with a 4.3 in it?

remove passenger front tire then fold back the water guard then you will access to the starter


What transmission goes in a 92 s10 blazer?

4l60e i got a 92 chevy blazer with the w engine it came with a 700 R


How do I removed the starter from my 92 Chevy S10 4wd pu 4.3 Ltr since I don't have enough room to remove it even after the bolts are loose?

remove the bolts holding the transmission inspection plate Best I recall there is like 4 or 5 holding it in place when the inspection plate is dropped the starter will come out at same time with a little wiggling I just replaced a starter in a 1993 s10 blazer 4.3 and experienced the same problem Hope this helps


How do you replace the EGR Valve on a 92 S10 Blazer?

What engine???


Can you put a vortex motor in a 92 s10 blazer that has a 4.3?

YEah


How do you get the starter out of a 92 Chevy s10 pickup?

Which engine is in it ? First disconnect battery remove torque converter cover if it is an auto trans remove starter bolts position so you can remove rest of wires stand starter vertical rotate and let it com out the bottom


Where is the temp coolant sensor 92 blazer s10?

Next to the thermostat housing.


Where is fuel pressure regulator on 92 Chevy blazer s10?

It is attached to the throttle body.


Wiring diagram for stereo on a 92 Chevrolet s10?

HOW DO I HOOK UP AN AFTER MARKET STEREO TO A 92 CHEVEY S-10 BLAZER


Where is the oil psi switch on 4.3 V6 CPI 92 Chevy S10 blazer?

Next to the distributor


A component locator for 92 S10 Blazer?

The AutoZone website has a component locator for the 1992 S10 Blazer. Select your vehicle make and model, then click on the Repair Help tab. On the left you will see several options, and one of them is the component locator.


Is there an inline fuse or relay for a 92 s10 blazer and where is it?

There are many fuses and relays in that vehicle, we need to know which one you are looking for.


Will a bad oil pressure switch cause the ecmb fuse to keep blowing on your 92 s10 blazer 4.3 liter?

NO.. It will not.


How do you locate and change the starter solenoid on a 92 Chevy S10?

The starter solenoid is located on the starter. It would be more cost-effective to have the entire starter replaced with a good remanufactured unit on this application.


Does a 94 jimmy windshield fit a 92 blazer?

Yes, AS LONG AS BOTH ARE EITHER FULLSIZE OR IF BOTH ARE S10/S15 TYPE BLAZERS. NO IF ONE IS S10 AND THE OTHER IS FULL SIZE.


How do you fix the cable for the hatch release on a 92 Blazer S10?

It depends on where its broke at. Is the cable broken at the mechanical part or is it broken before that?


Where is the voltage regulator in a 92 s10 blazer 4.3?

It is built inside of the alternator, Will have to replace alternator, it's all one unit.


92' Chevy S10 blazer what is the computer that controls the four wheel drive called?

TCCM Transfer case control module


What is diagnostic code 54 on a 92 Chevy s10 blazer 4x4 4.3 v6 tbi?

fuel pump low voltage


How do you change the lower left ball joint on a 92 chev s10 blazer 4x4?

Remove the tire and wheel from your 1992 Chevrolet S 10 Blazer. Removing the brake assembly and the brake rotor will give you more room to work. Remove the ball joint nut. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.


1990 s10 blazer loud clicking noise from transmission?

I have a 92 with the same problem. I wish someone would hook us up with an answer...


Just wondering if the front end such as the hood and side pannels from a blazer will fit a S-10 the blazer is a 89 and the S-10 is a 92?

S10 pickup is the same from 1982 to 1993.S10 blazer is the same from 1983 to 1994. The front ends will interchange.Also, the front doors on the four door models interchange with the two door models.Hope this helps!


How do you replace the starter in a 92' Chevy Lumina Z34?

Remove the positive cable from your 1992 Chevy Lumina battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.


1997 Chevy s10 blazer no reverse any ideas?

i have a 92 s-10 blazer and it has no reverse Andy ideas?. it will go in to drive and shift in to all the gears..but will no go into reverse? can u help me


How do you change a clutch in a 92 s10 pickup?

you need to remove the transmission then unbolt the clutch from the flywheel.