There is a third bolt at the top of the starter that is removed from the opposite direction through the block. The two bottom bolts came out one direction. The top bolt comes out the opposite direction. You have to feel for it, its there. See Haynes Repair manual, it doesn't spell it out but does have an illustration where the third bolt is.
If all bolts have been removed and motor still won't come out you'll need to tap the starting motor with something hard, like a hammer, but tap carefully and firmly this will help the starting motor to become looser and be removed.
Starter of toyota corolla and matrix is not the same. The best thing you do if you change your starter by yourself is to remove and compare to the new starter.
Same as a 1999. Look for "remove starter on 1999 Corola" post I answered. Same as a 1999. Look for "remove starter on 1999 Corolla" post I answered.
Remove the positive battery cable from your 1997 Toyota Corolla battery. Tighten the starter with the retaining bolts. Attach the cables to the front of the starter. Reattach the positive cable to the battery.
Replacing a starter on a 1989 Toyota Corolla is not very difficult to do. The wires will need to be disconnected from the old starter and labeled or taped. The starter is held in place by two bolts, unscrew the bolts and remove the old starter. Then replace with the new starter.
How i remove eveporator unit from toyota corolla 2002
how do you remove a center console on a 2001 toyota corolla
remove battery and tray, two, 17mm or 18mm bolts hold starter on. one on top of starter and one on bottom
under the manifold behind the block you might have to remove the airfilter to really see it
it is under the intake manifold. very hard to see and no fun to remove.
how do u remove cv axle driverside 1991 toyota corolla
Remove it and bench test it or bring to auto parts store they can test it for you
How do you remove the heater core on a 1997 Toyata Corolla?
which pully do i remove tension to remove the alternator?
REMOVE THE LEFT FRONT WHEEL AND THERE IS A SMALL PLATE TO BE REMOVED AND THE STARTER CAN BE REMOVED THOUGHT THIS HOLE THE BRAKE LINE MAY NEED TO BE LOOSEN AND MOVED DOWN
Its behind the motor (if you are facing the car). its a case the size of a rabbit, with 3 bolts. hard to find, harder to remove.
Remove the negative battery cable. Follow the posative cable down to the starter. remove the wires then the bolts holding it to the engine. Label the wires to make sure they go back where they came from.
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
The Toyota Corolla front bumper is held in place with eight retaining bolts. Remove the retaining bolts and the bumper will come off.
i don't know if the engines are similar enough for me to answer you question but i have a '85 sr5 and when i took off my starter, all i had to do was remove two bolts from behind the starter. you really gotta get down and dirty because they are BACK THERE! hope this helps you out.
It screws right out
Some vehicles require the motor mount (on the side the starter is on) to be loosened or even removed in order to jack up the motor to remove and replace the starter.
The type of the rear seat of the Toyota Corolla will determine how you will remove it. For instance, for a folding seat, all that you will need to do is to lower the seat to gain access.
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.