If this is an 80's model, it should be rather simple. The starter will be underneath the passenger side. After you find it, just remove the cables to it and the two bolts securing it to the block and it should slide out towards the rear of the car.
The starter relay on a 1999 GMC Suburban with the bib block engine is located on the solenoid for the starter. The solenoid for the starter is on top of the starter.
BEHIND the starter. You MUST remove the starter to get to it.
on top of the starter. you have to disconnect battery then remove starter to replace it
Unconnect battery. Remove cables and unscrew the old one located on the right side of the engine near the gearbox. Installation vice versa.
how to remove cross bars on a 2011 gmc yukon
It is behind the starter, You will need to remove the starter to get to it.
YES there is. You will need to remove the starter to see it.
remove starter remove transmission unbolt flywheel
My 2000 GMC Jimmy is slow cranking. The battery voltage meter is showing charged so I am assuming that the starter is the problem. Where do I find the starter to remove it?
To change the starter on a GMC Jimmy 95 you must look under the truck and locate the starter. There will be a bar in the way of removing the starter. You will have to remove the two screws and manuver the starter around the bar. This will be tricky so take your time. Once you remove the starter replace with the new one and manuver back in place screw in and your done.
Replace Remove starter Remove solenoid at top of starter Remove front end of starter for access Remove locking washer from starter shaft Drive should slide off shaft
First, remove the negative battery cable. Then remove the wires off of the starter. Then remove the 3 bolts that hold the starter on and work it out around the exhaust.