Could be that arrangement for the throttle was a "one of a kind" and possibly custom built for someone with disabilities or maybe an early attempt for cruise control. If it was assembled by someone you should be able to disassemble it. Take pictures and make notes as you take it apart.
4 bolts are romoved from the backsode of the steering wheel. If airbag equipped remove airbag fuse first. Then remove airbag/ horn/ center assembly. Remove large nut from center of wheel, then pull wheel with steering wheel puller.
take off center cover, remove large nut then use wheel puller to remove steering wheel
Take horn apart, remove center nut & use a steering wheel puller (carefully, when they break loose, it can be fun)
To remove the steering wheel from a Renault Clio one must first remove all screws from the back side of the steering column. Once all the screws are removed the steering wheel should be able to be wiggled free.
Usually, the bolt to remove the steering wheel from the column is located at the point where it attached to the column. If your steering wheel has a pressure switch for the city horn located in the center of the steering wheel, you'll have to remove it to access that bolt.
I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck! I had to replace a wiper switch on a 1992 Chevrolet Full size pick-up, and to do so, the steering wheel had to be removed. I think the models are similar. To begin, remove the horn cap, and in some models you may have to remove the attached wire. Go to autozone rent a "steering wheel puller" It has two rods the go in to the ones on the steering wheel and a center bolt that you turn to remove the steering wheel. Before you remove the steering mark where the steering wheel lines up with the steering column with tape. Good luck!
Remove horn ring or button (twist to remove) Remove center bolt on steering wheel Mark location of wheel in relation to steering column shaft for proper re-install Get and attach a steering wheel puller Tighten nut on wheel puller until steering wheel "pops" off
You need to get a special tool, steering wheel puller. If you have it, disconnect the battery. Remove the steering wheel air bag (there are two screws holding it in place). Disconnect the bag harness. Remove the center steering wheel nut. Using the puller remove the steering wheel. Installation is reversed to removal.
the steering wheel should have ridges on the center chrome peice, turn that peice and the steering wheel should come apart
remove the two screws holding face plate in center of steering wheel and remove plate. next remove large nut in center. Using a steering wheel puller remove steering wheel. next there is a pin next tothe lock cylinder. that will have to be driven inwith a hammer and a punch. lock cylinder should be able to be pulled out. installation is the reverse of removal.
power steering pulley is pressed on. to remove pulley, u need to completely remove pump from vehicle and take it to a mechanic that has right tools for removing
you need to remove the horn button,should just pop out of the steering wheel,then remove the center nut and you will need a wheel puller to pull the steering wheel,then the switch will be easily accessible