i have the double din in my 2000 ex coupe. if i remember correctly there are 2 screws on the bottom side of the center dash (right below the CD player). and there is a third behind the clock unit in the inside of the dash. you will need to disconnect the clock and the climate control but it is very simple. after you take out the third screw you should be able to remove that entire center portion rather easilly. after that just remove the screws (use a magnetic screwdriver as some are on accessable by tool and my be lost without it) on the metal part of the din and install your new head unit.
Follow the instruction in the link to remove the plastic cover http://www.installdr.com/InstallDocs/Honda/PDF/466053.pdf
150 at 5,700 rpm
There are screws that hold them on. You have to just find them.
Use a 14mm box wrench.
yes it comes stock
I need to find out the timing degrees on a Honda Accord 2000
you push the eject button. seriously its right in front of you
The bulbs unscrew counterclockwise from the back of the light assy. Sometimes you ave to remove the light to get to it.
yes. to get to it, you probably need to remove the glove box and lower panel.
There is an access panel in the car just above the fuel pump. Remove that panel and you can access the pump.
go to strutmasters.com
No. They are a different lug pattern.
* Disable the airbag system * Remove the center bezel panel from the dash and the plastic panel just below the ashtray * Remove the screws and pull the air conditioning controls/radio/Cd player assembly away from the dash * Disconnect the antenna lead and the electrical connectors then remove the screws at each side bracket to remove the radio or Cd player from the air conditioning controls/radio/Cd player assembly
Yes i had a 2000 accord 4 cyl, with 1995 accord rims on it,,, from 1990 to 2003 will fit as long as its a 4cly,, the v6 all have 5 lug,, but the 1995 accord to 1997 v6 had 4 lug to,,
It's probably a 32 or 36mm impact socket a wrench probably won't work.
No, there is no stock amp on a 2000 Galant
The stock symbol for Avaya in 2000 was AV. The stock traded on the NYSE.
To remove a factory CD player from a 2000 Honda CR-V first inspect the center console of your vehicle. There should be several mounting screws holds the CD player. Remove them and proceed to slide the unit out of the center console. Lastly remove the wiring clip behind the radio.
The 2000 Accord does NOT have the LATCH anchors. It does have 3 tethers.
No, the 1996 is the 5th generation Accord and the 2000 is the 6th generation. The hoods are not even close to the same.
Remove the wheel then remove the two calipher bolts that hold the calipher to the spindle. Then remove the calipher assembly out of the way and support it. Do not allow the calipher assembly to hang from the brake hose. At this point the rotor can be removed......1930fcoupe