im trying to find out the same thing
230-235 stock hp
it is 8"
how do you remove the stock radio on a 1996 lexue es300
Begin by removing the decorative radio retaining cover. Remove the radio retaining screws. Slide the radio out, remove the wiring harness and the antenna cable from the back of the radio.
read the manual that came with the radio or ask a friend that is good with cars!!
You pull out the Stock radio and buy a box to put in in then remove the center dash peice by pulling the bottom and cafully the top. then you can undo the wireing clip behind that and by a new center peice that is made for a radio.
This requires a special tool to remove and install the pulley. Most auto parts stores should have one in stock Best to remove the pulley with the pump removed from the engine compartment.
Not on my 2006 Uplander.
With the help of a Trim Tool, carefully remove the Center Trim Panel from around the Radio. Remove the 4 screws. Pull out Unit. Disconnect Electrical Plug & Antenna. Installation is reverse.....
Remove the decorative cover to your 2001 Chevy Lumina stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness. Remove the antenna cable.
* Remove the ashtray and ashtray holder * Remove the radio and mounting plate screws and lower the radio and unplug the electrical connector and antenna lead then push the radio out of the dashboard
You will need a computer tech tool, available at any Chevy dealer. You cannot do it without it.
1. Remove the trim around the radio. This will be the whole dash trim on the driver's side. 2. Remove 3 x 7mm screws that are holding the radio in place. 3. Unhook the 3 connections (2 x wiring harness and 1 x satellite cable).
you must first pop the bezel off. there will be 2 screws over the gauges that will need to be removed also. there are 4 screws on the outside corners of the radio and 4 screws on the temperature controls. you will need to take all of these out and the radio will fall out. remove the CD holder from the sides and back and you are done.
Salvage yard or through the dealership
The stock radio on a 2008 Ford F550 is removed by removing the trim and cover panels, disconnecting the wiring harness, and taking out the retaining screws. The radio can then be slid out of its housing and removed.
you will need to unscrew your dash and pull off the front plate of your dash, then you will need to unscrew the stock radio, then you will need to go ahead and pull out the adapter from the back of your radio.-Shocker
Remove Stock Ford RadioCheck related link below
how do you remove the stock radio from a 2000 ford focus zx3 Go to walmart in the car stereo section. In there, there are these packs of 2 U-shaped metal rods. If you buy theses, stick them in the correct holes in the radio then it will pop right out.
remove the exterior trim peace that surrounds the outer edges of the radio. Then there should be either two 10mm bolts or four phillip head screws holding the radio in place remove them and gently remove the radio from it slot and then unplug the wire harnesses and antenna in the back of the radio. repeat in reverse to reinstall.
you will need to unscrew your dash and pull off the front plate of your dash, then you will need to unscrew the stock radio, then you will need to go ahead and pull out the adapter from the back of your radio. and that should do it-Shocker
AM/FM radio was a VERY rare option in 1963. Very few had them. Most had AM only, and many came with no radio at all.