im trying to find out the same thing
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
Not on my 2006 Uplander.
you will need to unscrew your dash and pull off the front plate of your dash, then you will need to unscrew the stock radio, then you will need to go ahead and pull out the adapter from the back of your radio.-Shocker
I did this not long ago in my ranger. There are four hole in the front of the radio, you must remove the trim around it to see them. They are on the four corners. They make a tool that fits in the holes and pushes the clips in and the radio pulss free. I used four drill bits that just fit in the holes. luck.
1. Pull both side console panels off the center console. (These are by your feet in the front). 2. Remove the screw on either side that has the shifter panel attached. 3. Pull the shifter panel up at the rear and down at the front to pop it off and pull it back a little. It won't remove completely due to the shifter. 4. Remove the two screws that you just exposed below the traction control/hazard/airbag panel and disconnect the wires attached to the panel. 5. Carefully pull the trim up from around the HVAC controls and the radio. You also have to remove the center wood piece. 6. Now you can remove the screws holding the HVAC and the radio in place and pull the radio out.
Remove the center bezel and the glove box. Take out the four screws holding it in and then reach through the glove box opening and remove the mounting bracket screw then push the radio forward and unplug the connector and antenna. That's it.
Remove the 1993 Toyota decorative radio cover in. Remove the radio retaining screws. Pull the radio out. Remove the wiring harness.
You pull out the Stock radio and buy a box to put in in then remove the center dash peice by pulling the bottom and cafully the top. then you can undo the wireing clip behind that and by a new center peice that is made for a radio.
read the manual that came with the radio or ask a friend that is good with cars!!
Not on my 2006 Uplander.
With the help of a Trim Tool, carefully remove the Center Trim Panel from around the Radio. Remove the 4 screws. Pull out Unit. Disconnect Electrical Plug & Antenna. Installation is reverse.....
1. Remove the trim around the radio. This will be the whole dash trim on the driver's side. 2. Remove 3 x 7mm screws that are holding the radio in place. 3. Unhook the 3 connections (2 x wiring harness and 1 x satellite cable).
You will need a computer tech tool, available at any Chevy dealer. You cannot do it without it.
* Remove the ashtray and ashtray holder * Remove the radio and mounting plate screws and lower the radio and unplug the electrical connector and antenna lead then push the radio out of the dashboard
Remove the decorative cover to your 2001 Chevy Lumina stereo. Remove the stereo retaining screws. Slide the stereo out and remove the wiring harness. Remove the antenna cable.
Salvage yard or through the dealership
you will need to unscrew your dash and pull off the front plate of your dash, then you will need to unscrew the stock radio, then you will need to go ahead and pull out the adapter from the back of your radio.-Shocker