1. Pull both side console panels off the center console. (These are by your feet in the front).
2. Remove the screw on either side that has the shifter panel attached.
3. Pull the shifter panel up at the rear and down at the front to pop it off and pull it back a little. It won't remove completely due to the shifter.
4. Remove the two screws that you just exposed below the traction control/hazard/airbag panel and disconnect the wires attached to the panel.
5. Carefully pull the trim up from around the HVAC controls and the radio. You also have to remove the center wood piece.
6. Now you can remove the screws holding the HVAC and the radio in place and pull the radio out.
you will need to unscrew your dash and pull off the front plate of your dash, then you will need to unscrew the stock radio, then you will need to go ahead and pull out the adapter from the back of your radio. Next you will need to attach your adapter harness to your car harness and splice the color coded wires to the harness on your new CD player.After that, you will need to plug your antenna back into your new CD player, Note that some CD players will require an adapter, these can be found at circuit city or at your local car dealerships.-Shocker
Begin by removing the decorative radio cover in your 2006 Chevy Malibu. Remove the radio retaining screws. Remove the wiring harness and the antenna cable from the back of the radio.
Not on my 2006 Uplander.
Easy job on the 2002. Turn the two center air vents down and look inside above them. You will see a screw in each. Remove the screws and the face plate will come off. The radio is then bolted into the dash and can easily be removes. I hope no car radio theives are reading this!
There are two special tools that look like keys that are inserted to release locking tabs.
You must insert the 5 digit code. If you cannot find the code, then go to the selling dealer. They may have it on file. If not, you will have to remove the radio the get the serial # off the radio chassis. With that serial # the dealer can provide the code. There is no other way.
Its for installing an auxiliary audio device, like a CD changer or a satellite radio. You have to remove your radio to attach a device to it. There was no auxiliary input in the 2003 Toyota matrix and was not optional the first aux was for the 2006 matrix and up
what steps are required to remove the inside door panel on a 1997 Chevy Malibu.
where is the Starter on a 2006 Malibu Maxx LT
I believe it is 16mm
What is the spark plug gap for a 2006 chevy malibu 3.5L v6
How do you program a key fob to a 2003 Chevy Malibu
To take off the das in 2006 Chevy Malibu you need to take both the IP and end panels off by unclipping them on place. After that, remove the 7mm bolts that hold the driver knee bolster in place.
No.
Traction Control
Yes there is and it caps at 180KPh
The 2006 Chevy Malibu does not have an accessible fuel filter. There is a filter within the tank that should only be serviced at a Chevrolet service center.
how do i change my blower motor on my 2007 malibu
Measure it.