answersLogoWhite

0


Best Answer

pull it out?

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the throttle cable on a 1996 Beretta?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace a speedometer cable in a 1996 Honda civic?

There is not speedometer cable on a 1996 Honda Civic. There is a throttle cable. Top replace this unhook it from the throttle body and gas pedal. Hook on the new cable to snake it through the firewall. Properly hook the throttle cable to the gas pedal and throttle body.


Does a 1996 Ford Explorer have a throttle cable?

Yes it does. It reaches from the gas pedal to the throttle body on your intake.


Where is the thermostat located and how do you replace it located on a 1996 Oldsmobile Ciera?

1996 3.1 litre ThermostatThe thermostat on a 3.1 litre is located under the throttle body where it connects to the intake manifold. I found it was easier to remove the throttle body when replacing the thermostat. You first have to remove the throttle cable bracket that is mounted on the throttle body. After that you will be able to see the thermostat housing. The bottom hole on the thermostat housing is slotted so you don't have to completely have to remove it. Good luck!


Why does Throttle stick on 1997 Honda Passport?

I had a stuck throttle on my 1996 Passport. The throttle cable had a piece of protective black rubber around the throttle cable between the outer cable covering and where the cable connects to the throttle body. The rubber had began to come apart and some of it was getting inside the throttle cable covering, causing the throttle cable to bind. I removed the rubber piece and cleaned out the cable by covering it with GOOF-OFF and then sliding the cable in and out until my cleaning rag was clean when I wiped off the cable. I did not replace the rubber piece and have had no problems since.


Where is the tps sensor on a 1996 S-10?

The throttle position sensor can be found on the throttle body, opposite end of the throttle cable end of throttle plate shaft.


How do you replace the exterior mirror on a 1996 Beretta?

To replace the exterior mirror on a 1996 Beretta, find a small plate on the inside of your door. Remove the screws and install the new mirror.


Where can you get the throttle cable that goes from the transmission to the throttle body for a 1996 geo tracker?

AnswerAT A JUNK YARD $ 334-283-4982It is not a throttle cable. It is a kick down cable that engages a lower(passing) gear when the throttle is quickly advanced.You can probably get one at Autozone or NAPA Auto Parts.


What causes gas pedal to stick while driving a 1996 Ford Ranger?

Take it to a mechanic ASAP. This is very dangerous. a cause of is the throttle cable fraying replace the throttle cable.


How do you remove the clutch cable on a 1996 Chevy s10?

There is no cable, it is hydraulic operated.


How do you replace valve cover gasket on a 1996 Pontiac grand am gt 2.4L?

Should be able to just unbolt the valve cover, remove the old gasket clear the surfaces with a rag and reinstall. Might have to disconnect the throttle/trans kickdown cable from the throttle body for room.


Remove the headrest from a 1996 beretta?

you must remove fabric from the upper seat there is a lock clip at the bottom of the post.. for more info... http://www.topspeedautogroup.com


Where is the throttle position sensor located on a 1996 Oldsmobile 98?

On the bottom of the throttle body - look where the pedal cable meets with the throttle body - look opposite the end of the connection assembly on the other side you will see the throttle position sensor.