Pull gently but firmly. It is held in by push pins. You must check to see if there are any trim or molding screws holding it in place. Remove any cover doors to ensure there are no securing screws in place. GM sometimes puts little flip off caps over the screws.
Start in a corner and slowly work your way around.
Relatively easy job. Remove rear plastic panel on the inside cargo area. this will expose the nuts and bolts etc. www.trailvoy.com - All the answers for your Trailblazer from true enthusiasts!
We have a "how To" for the dashboard area. Then once you buy a chime module and a good deck you can get rid of that horrible piece of Delphi electronics and start moving the vehicle sound in the right direction. www.trailvoy.com Trailblazer enthusiasts forum
It is usually in the engine comprtment either on the left or right sides near the wheel area. It will have a cover over the top of it. Remove the cover. Good luck.
c/v axle is bad if its front wheel drive
Remove positive battery cable. Remove right front wheel. on fender behind wheel well is a flexible cover- remove it. Use 13mm wrench and remove power cable to starter sol. use 5/16 in. wrench to remove signal wire on started sol. remove two bolts holding starter up. jack the motor up from the oil pan and wiggle it out of tight area between bellhousing and frame. With new starter just reverse to install.
i believe you can disassemble the lower part of the steering column to access the area.
Front wheel speed sensors are located on the wheel bearing assemblies. I believe there is one bolt holding the sensor in. Make sure the area near and around the sensor is clean, if you knock any dirt dust into the open sensor shaft it will go directly into your wheel bearing, causing more issues. Pull sensor out firmly and straight. Do no pry sensor out with anything, as you will bust sensor off in shaft. Do not attempt to remove the stainless shim, as it is permanently fixed to the assembly. Clean the area if needed, then insert the new sensor carefully. Again, remember to not get dirt inside of the wheel bearing assembly, or you will be replacing the entire assembly soon enough.
In the area in front of the right front wheel below the headlight.
Wheel bearing?
on the back of the steering wheel neer the center area not the part you hold in your hands behind the horn area there are 4 torx or metric bolts remove those bolts and the air bag can be removed do this only after you have disconected the battery
The smog pump is located under the vehicle, on the drivers side, bolted to the frame rail, right under the drivers seat area
the location of the horn on the pug 307 is located in the nearside inner wheel arch, To get access you have to remove the wheel and the plastics in the area and once done there you have it right in front of your eyes. Hope this helps...........Also maybe worthwhile thinking of the comms module on the back of the airbag..I hear these can be problematic too.