There is a retainer clip that holds the handle onto the spined shaft. There is a plastic piece between the handle and the door panel, I used a screwdriver to make a gap between the handle and this plastic piece. through the gap I was able to see to use a crochet needle to hook and pull the retainer clip loose. Once the retainer clip is loose the handle easily pulls off the spined shaft.
If there is no faster head visible then it likely is attached with a clip on the backside of the crank handle. slip the handle between the handle and door panel to remove the clip.
TAke off the window regulator handle and door handle then remove all of the screws you can find at the corners etc then remove the retainers around the sides and bottom of the panel. This requires a special tool availavle at parts stores.
how to remove the vent from dashboard of 1996 ford contour
there is about 7 screws in the front door and u have to take the pin out for the window crank unless its power windows there s screw where the handle is and where u open the door on the inside
How to Remove or Install Car Window Crank Handles check related link below
brake the window
There should be an Allen head screw in the middle of the connection.
dynamite
You don't.
carefully pop off the plastic cover on the handle and in the center there will be a screw
remove the window handle, remove screws from armrest, remove the inner door handle and the screw on the lower rear of the door panel, lift the panel upwards to remove from the slots along the bottom of the door.
get a mechanic? (are you retarted?)