bang the joint (where the arm pivots) with your palm. this will free it from the tapered shaft.
The 2005 Toyota Sienna had a production change mid-year that affected the wiper configuration.Step 1 is to measure the length of the blade on your vehicle. "Early" Production 2005 Toyota Sienna: 14" Special Rear Wiper Blade"Late" Production 2005 Toyota Sienna: 16" Standard Rear Wiper BladeStep 2 is to be sure you get the right replacement wiper blades.Step 3: The replacement wiper blades will come with simple-to-follow, step-by-step, illustrated instructions
change the wiper fluids, or get it checked out
Remove wiper arm caps, nuts & arms. Remove cowl louver cover. Disconnect wiper motor electrical connector. Remove 6 bolts and remove wiper linkage assembly. Disconnect wiper link from wiper motor. Remove 4 screws and wiper motor from firewall.
My 2003 Sienna has one tank that is for the front and rear window. You might have a problem with your pump or something else. Does your front wiper work?
http://letmegooglethatforyou.com/?q=how+to+remove+wiper+arms
Drivers side 26'' Passenger side 19''
Step 1 is to be sure you get the right replacement wiper blades. The 2000 Toyota Sienna takes 24" driver side, 18" passenger side replacement windshield wiper blades on the front and a 17" replacement rear wiper blade. Step 2: As far as installation, the replacement wiper blades will come with simple-to-follow, step-by-step, illustrated instructions.
The 2004 Toyota Sienna has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.
Once you get the correct rear wiper blade, its literally a snap! The wiper blade is tough to find, however see below. Also see below for an installation video.
Pop off plastic cover and tighten nut. See the Sources and Related Links section below for wiper blade info.
Begin by removing the wiper motor wiring harness. Remove the traveling arm linkage retaining bolt. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.
The 2004 Toyota Sienna has the most common hook-end wiper arms. See sources and related links below for installation videos. Also, purchase the replacement blades first and there will be additional instructions/illustrations on the replacement packages. Locate and press the tab or button where the wiper blade is inserted into the hook of the wiper arm and pull wiper blade out of hook. You may have to rotate and flex the blade to make enough clearance for the hook to pass through.