0
How do you remove thermostat housing on 1998 Pontiac transport?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change the thermostat on a 1993 Pontiac Transport?
follow the top radiator hose to the engine. that is where your thermostat is. you will have to drain the radiator, remove the engine side of the hose and remove the thermostat housing to access it. remove thermostat clean mating surface of housing and engine, install thermostat, install housing, secure radiator hose, fill with coolant. start engine and check for leaks.
What is the correct way to insert a thermostat on a 1997 Pontiac sunfire 2.2?
Remove the thermostat housing screws and separate the housing, exsposing the thermostat and coolant, remove old thermostat and gasket. Reinstall new thermostat, gasket and coolant.
Where is the thermostat on a 1995 Pontiac firebird?
Follow the top radiator hose, to where it intersects with the motor. This would be the thermostat housing. Remove this, and the thermostat will be exposed.
How do you replace a thermostat in a 1996 Pontiac Grand Prix SE?
Is the engine a 3.1? If so it is easist to remove the crossover pipe, then the thermostat housing.
Where is the thermostat in a 2004 Pontiac grandprix?
2004 Pontiac thermostat Service and Repair 2004 Pontiac Thermostat Replacement 2004 Pontiac Removal Procedure : 1. If equipped with an automatic transmission, remove the exhaust manifold. 2. Drain the cooling system. 3. Remove the thermostat housing to water pump feed pipe bolts. 4. Remove the thermostat housing to water pump feed pipe. 5. Remove the thermostat. Installation Procedure 1. Install the thermostat. 2. Install the thermostat housing to water pump feed pipe. Notice: Refer to Fastener Notice in Service Precautions. 3. Install the thermostat housing to water pump feed pipe bolt. ^ Tighten the thermostat housing to water pump feed pipe bolt to 10 Nm (18 inch lbs.). 4. If equipped with an automatic transmission, install the exhaust manifold. 5. Fill the cooling system.
How do you replace the thermostat located on a 1991 Pontiac Bonneville 3800?
I believe you want to drain the coolant, remove the top hose at the thermostat housing, remove the housing, replace the stat and gasket, reassemble fill with coolant and bleed the system.
How do you replace the thermostat on a Peugeot 206 cc?
Remove the thermostat housing. where is, and how do i remove the housing
How do you get the thermosta out of a VN V6?
Remove the hose from the thermostat housing then remove the housing and then the thermostat.
How do you replace the thermostat on a 1997 Pontiac grand am 3.1?
To replace the thermostat on a 1997 Pontiac Grand Am 3.1, first disconnect the negative battery terminal and loosen the clamp on the radiator hose. Next, remove the mounting bolts from the thermostat housing and insert the new thermostat.
Where is the thermostat located in the 2002 Pontiac Montana?
first drain the coolant at the bottom drivers side rad follow the top rad hose on drivers side to the motor the housing it is clamped to is the thermostat housing remove the air intake tube & throttle body two bolts hold the housing in place remove them slid the hose and housing out when installing be sure the thermostat is seated or you will break the housing
Where is the location of the thermostat on a 1994 Pontiac grand prix?
if you take the cap off of the radiator it is in there actually no its not. follow the top radiator hose to the engine. that is where your thermostat is. you will have to drain the radiator, remove the engine side of the hose and remove the thermostat housing to access it.
Have been unable to find the thermostat housing on a 1992 Pontiac Lemans to change the thermostat that is stuck open at 30 below the car won't warm up at all?
The thermostat housing is behind the camshaft sprocket. Remove timing covers and belt then remove camshaft sprocket and then rear timing cover. .
