Get the 'U' shaped radio removal tools (Wal-Mart or auto parts store just a few dollars). Follow the directions or: Squeeze the tool enough to insert the two ends (at the same time) into the two holes on the far left (right) of the radio face plate until they lock in (about 1-1.5 inches). Then do the same thing on the other side. Grasping both tools at the same time push in to the center and pull out. Then unplug the antennae and other connections and you are done.
The only recalls that were for the 03' Mazda Protege 5 were all for the Exterior lighting. The first two were in May of 2008 and the other was in April of 2009.
yes, protege 5 is 01-03 yr you can fit the protege same years for i direct swap and if you want an older engine youll nee the ecu and matching harness.
Have you tried to put it back? It may just work, if you want to replace the radio I would bring it to the dealer
I just replaced a wheel bearing in my, 03 protege 5 it was $60 for the part and $60 for the mechanic to press it in.
I had one installed on the 99 model at a shop. this is the same run line, 99-03.
You have to go inside the trunk and remove the circular plastic covers from behind the lights. Then you have to unscrew the entire light and you can access the bulbs to replace them.
http://how-to-gps.blogspot.com.au/2012/03/how-to-install-mitsubishi-grandis-gps.html
* Remove the ashtray and ashtray holder * Remove the radio and mounting plate screws and lower the radio and unplug the electrical connector and antenna lead then push the radio out of the dashboard
Victoria Radio Network was created on 1971-03-03.
You Tube "Happywrenching.com". Incredible video on how to change rear drum brakes on a 99-03 Protege. Did the entire brake job myself! :)
It is broken.
01-03 Tribute. Remove the two screws on the inside lip. The tail light pulls straight out towards the rear. What you can't see is that it is held in by 2 snaps on the outboard side.