In which vehicle?
To change the Transmission Speed sensor, G68, remove battery and battery tray. The sensor is below the battery tray. A 10mm socket will remove the bolt that attaches sensor to transmission. Unclip plug and pull sensor out.
Inside the Transmission. You need to remove the Transmission Oil Pan to have access to it...
The speed sensor can be found on the side of the transmission and can be easily removed with a 9/16 ratchet. Remove the wiring harness from the speed sensor before removing the speed sensor from the transmission.
To remove the speed sensor on a 1993 Mazda MX-6, first, locate the sensor, which is usually found on the transmission. Disconnect the electrical connector and then remove the retaining bolt or nut securing the sensor in place. Gently pull the sensor out of the transmission, taking care not to damage any surrounding components. If necessary, replace the O-ring before installing the new sensor.
range sensor is located inside transmission. remove pan and it is attached to shift selector rod and vave body.
To replace the transmission sensor on a Ford Windstar, first, ensure the vehicle is safely parked and the engine is off. Locate the transmission sensor, typically found on the transmission housing; disconnect the electrical connector and remove the mounting bolt(s) securing the sensor. Remove the old sensor and install the new one, securing it in place and reconnecting the electrical connector. Finally, check for any leaks and ensure proper functionality before driving.
You must remove the transmission pan and fluid. There are 18 hex bolts holding the valve body on. Remove them. Next remove air cleaner assembly on top of the motor and remove linkage to top of tranny. After valve body is removed you will see the sensor.
To remove the speed sensor from a 1994 Isuzu Trooper, first ensure the vehicle is on a level surface and the ignition is turned off. Locate the speed sensor, which is typically found on the transmission housing. Disconnect the electrical connector and use a socket or wrench to remove the retaining bolt. Once the bolt is removed, gently pull the sensor out of the transmission.
on the left side of the transmission is a sensor. carefully remove it and pump/squeeze fluid in that opening up to the bottom of the hole. replace sensor.
The speed sensor is found on the transmission of the 1992 Honda Civic. To replace the unit locate the mounting bolts and remove them. Unplug the wiring clip and pull the sensor off.
remove the engine and transmission from the car, then remove engine flywheel and it will be right there
The speed sensor on a 1994 Honda Civic is located on top the of the transmission. To replace it unplug the sensor from the wire harness then the remove mounting bolts and assembly from the transmission.