answersLogoWhite

0

How do you remove valve cover on 1996 caddilac?

Updated: 8/16/2019
User Avatar

Wiki User

9y ago

Best Answer

The valve cover on a 1996 Cadillac is held on by several bolts around the edge. After removing any hoses, fuel rail, or anything else in the way, remove the bolts to pull the valve cover off.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove valve cover on 1996 caddilac?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1996 Toyota Camry valve cover gasket?

how do i remove the valve cover to change the gasket in a toyota camry 1996


How do you remove a valve cover on a 1996 Hyundai elantra?

CAUTION: Some models are equipped with anti-theft-radio make sure you have the activation code before disconnecting battery * Disconnect negative battery cable * Detach the accelerator cable from the cable guides on the valve cover (It's not necessary to remove the cable guides unless you're replacing the valve cover) * Disconnect the PCV and breather hoses from the valve cover * Remove the spark plug wire cover bolts remove the cover and then remove the spark plug wires * Remove the bolts that attach the upper timing belt cover to the valve cover * Remove the valve cover bolts and then remove the valve cover


Where do you put oil in a 1996 dodge stratus?

Remove the cap on the valve cover and pour it in there.


How do you remove the front valve cover on a 1996 deville northstar engine?

you dont. a cadillac tech does


How do you remove black plastic cover over alternator wires next to valve cover on 1996 Toyota Camry with 2200 4 cylinder so you can replace the valve cover gasket Can't get valve cover off?

remove the "dog bone" engine mount. then the 2 upper 10mm bolts on the timing belt cover. this will allow you to pull the harness out of the way to remove the cover.


Where is the PVC valve located on a 1996 Tracker?

Standing in the front of your car facing the engine, in the middle of the valve cover on the left side (covered by black plastic). Remove that black plastic cover and you will see the PVC valve on the left side of the valve cover.


How do you change the valve cover gasket on your Isuzu Trooper?

Remove Camshaft fro isuzu trooper 1996


Where is the valve cover set for a 1996 Honda Accord?

Please restate the question. What are you talking about? Valve cover gaskets, valve cover, what? need a valve cover


What tools are needed to remove the valve cover on a ford escort 1996?

If it is a 1.9L it takes a box or open end wrench in 10mm to take the 2 bolts off in the center of the valve cover.


Where is the PCV valve on a 1996 ranger 4.0?

On a 1996 Ford Ranger , 4.0 : The PCV valve is on top of the drivers side engine valve cover , near the rear of the valve cover


How do you change valve cover gaskets on a 1996 Isuzu Rodeo?

you have to remove the intake manifold then you have to remove the ignition coil and then remove the 8 bolt on each side (have fun removing the bolt) jejejeje then you take the cover off an you finish


How do you Replace a valve cover gaskets in 1996 buick regal custom?

remove motor mount "dog bones" and also label/remove spark plug wires from spark plugs, remove valve cover, clean cover from debris, use light coat of oil to stick gasket, replace round rubber gaskets, replace cover, wires and "dog bones"