Locate it on the upper brake pedal arm, disconnect the wire from it, unscrew it and put in a new one. Before doing that, of course, you need to make sure your fuse isn't blown and that the bulbs aren't burned out. If you have to replace the switch, disconnect the battery ground just to make sure you don't burn something out.
You need to replace it. There are 2 screws that hold it on.
if it isn't a fuse or lamp problem, check the brake lamp switch on the brake pedal, if you unplug the switch, and jumper the connection, and you have brake lamps, replace the switch...
It's a discharge lamp with a quartz envelope. I don't think there's really a way to repair it other than replace the lamp, IF that's the actual problem. Many other things can cause the lamp not to light, like a loose cover which deactivates a safety switch among other things.
A can or lamp shade
A lamp holder that turns on from a wall light switch not a switch on the device.
You need to go to a car parts store, and get a repair manual for your car. They cost about $16.00
If the tri-light needs a new lamp holder try any reputable lighting house store. These types of retailers have all of the parts that you need to repair any lamp configurations. The new switch will have a rotary switch built into it just like the lamp had when it was new. There are only two wires to connect to it. Don't disconnect the old one until you have the new one and just put the wires on the same terminals as the they are wires on the old switch.
no because when you remove the lamp the circuit is still open; even if the switch is on
The stop lamp switch is on a bracket above the brake pedal.The stop lamp switch is on a bracket above the brake pedal.
press the button
yes of-course
Pull out on the headlight switch.