ok i have a 1994 Ford Probe 2.0, it should be the same, the alternator is behide the engine, i did it with just normal tools and didnt have to remove the cross member or half shaft, what i did is
1 remove negative terminal
2 jack the car up as far as you can
3 i unloosend the bolt that moves the alternator back and forth a little then went under and loosend the mounting bolt as much as i could
4 then i went back to the bolt that moves the alternator back and forth and took it out completely (pain in the butt bc u can only move the wrench 1/2 a turn a time, use extensions if u have)
5 remove the mounting bolts completely
6 then with the bolts out i used a hammer to remove it from the mount under neath
7 now with it free i took off the wires (thee is a nut holding the negative on pop the black cap with a flat head and remove it.
8 then i removed the mounting bracket (3 bolts)
9 then here comes the fun, i took the old alternator out by the half shaft i used a hammer and cow bar, and twist it so the pulley is facing the other pulleys (or just how eve u can)
10 to get the new one in all i did was play with it to get it over the half shaft and a little muscle to push it up in and got it.
11 then just reinstall everything.
there is 2 other ways to do it and one is remove the half shaft and that would make life simple also u can remove the crossmember and pull it out back and down by the exost pipe
it took me 2 days to figure this out so i hope it helps
the bolts are all 1/2 or 7/16
you can't repair one you would have to buy a new one and put it on
In the alternator. Have to replace the Alternator.
if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450
yes....
Yessir, it will.
no, the 89-92 engine/transmissions are different from the 93-97 ford probe.
Replace it.
: AutoZone.com now offers some of the best vehicle repair information on the Internet for free! Their repair guides offer detailed information about your vehicle - everything from step-by-step repair instructions to wiring diagrams are included in each guide! : For Ford Probe wiring diagrams, go to: ; : http://www.autozone.com/Ntt,1994%20ford%20probe%20wiring%20diagram/shopping/allResults.htm
stock enginestock engine in 1994 ford probe GT is a Mazda 2.5L 24 valve V6.
I have a 97 Ford probe and when I had to replace my alternator... I had to pulled the passenger tire off and pull the whole assembly apart so I could get the alternator.. There are 2 bolts to loosen up and pull the belt out slide the alternator down by the exhaust and pull it out by the CV axle
Alternator . check voltage
If you're mechanically inclined I recommend you buying a Chiltons or Haynes repair manual for the 1991 Ford Probe. Most provide the info on removing and reinstalling the starter. Also you might check your local library/s for these manuals. , EzForJesus the alternator is located behind the engine. the passenger side axle shaft must be removed in order to get the alternator out. make sure you disconnect the battery first.